Does anyone have the size of the bench seat that folds down in a 1988 Sea Ray Weekender 300? My boat came without and my next project is to recreat the bench seat. I need the dimensions, or, if anyone knows where I might be able to pick one up, that would be useful as well.
Thank You
Weird occurance tonight. Started port engine - ran fine, nothing in the starboard battery so I used the emergency start switch to parallel the batteries. Starboard engine would run for a short time then choke out. Had no problems with the batteries till I worked on the dashboard panel. Sounds...
Restoring my older 300, and just wondered if anyone has any ideas on how to restore that faded burgundy dash. Is it paintable, if so what type of paint did you use?
is there a cleaner that will get that faded look restored?
some time ago I aquired a Sea Ray Navigator II unit. I dont have the power cord for it. Is this thing worth anything, or is it best used as a stern anchor? Thinking of putting it on craigslist, but I have no idea what to ask.
1988 Weekender 300 with twin 5.7 Mercruisers direct drive. What gals./hr fuel burn rate will I be looking at roughly? Have to bring it back on the water, and just wondered what to expect. I realize every boat is different, just looking for a rough estimate.
Anyone have a picture of a properly mounted driver seat for a 1988 weekender 300 ? Project boat fun, but this seat is making me crazy. There is a slide in bracket mounted to the side, and the lower part of the seat is not mounted at all. This doesn't seem right, but it have nothing to go from...
Interesting that my boat has done this a couple of times now. Once planed out and running (everything is fine) suddenly the boat wants to lean to the right and pull to the right. Slow down and all is good. Everything runs fine, and no probs to speak of, just freaks my wife out a little. Is this...
Hey guys, new to the CSR site....fantastic resource. I'm looking for any of the cables and power supply units for the Sea Ray Navigator 2 unit. I was recently able to purchase the CPU off of ebay, but it came completely bare, and I need to locate all of the hardware for it. I have the GPS...