My 500DA 2004 will it need the single transducer 0 degree needs center flat pad transducer must see both sides?
Or the Two pack 12 degree or 20 degree?
where can I find a scratch with specs. of the bottom of my boat?
I am pulling my boat out soon, availability ?
Thanks,
WarrenG
I have a GHS lift on mine and it was going up and down crooked but would latch on top.
I called GHS and they were super helpful! I needed to replace my proportioning valve at about $140 del. I was first instructed how to remove it and clean it to see if that worked before selling me the valve...
Mine runs really nice with the Cummins QSM11's, can carve full over turns without cavitation.
Have owned it for 2 yrs and could not be happier with my Sea Ray Choice.
WarrenG
I have a factory installed GENERAL HYDRAULIC SOLUTIONS lift on my 500DA and have had very few issues and the company is super responsive to deal with. The hydraulic lift is the best option on the yacht. We lower it just below the water and have our own beach etc. without it you are siting 2'...
Try http://www.searay-parts.com/ I have had great luck with them and they have a ton of hardware! I have found most everything I have needed to replace hardware.
Hope this helps,
WarrenG
We love our layout especially the cockpit. The port stateroom bottom bunk is a large single. We do have friends in their 50's that both sleep in it and another couple that one sleeps there and one on the coach in the salon. The top bunk is hard to get into, young adults, kids and storage. We...
My coolmatic freezer RSF-115 just went out. No parts available and not made anymore. A RV repair could not fix it but found a company that had 3 in stock @ about 2K del. I decided not to buy a new unit that had not parts available. There is an option I was offered by the RV repair, they could...