Search results

  1. J

    Ordered new 4x4 props for my 270 slx B3

    Sounds like a proper conclusion from a logical thinking approach.... So long as the drop/lower WOT is not some other issue. Good luck!
  2. J

    BIII clunks when shifting

    Is there a delay when the drive engages after you shift?
  3. J

    Pros and cons on installing a finn on a merc.350 br 3, for faster planing out

    I have a 2007 240 SunDeck 350 Mag BrIII.... Six people on board and it jumps out of the water and on plane in no time at all.
  4. J

    Trim tab rocker switch... Which way is up??

    KC just told you.
  5. J

    Beaching at Caladesi, Honeymoon or Anclote

    If in the area, definitely check out Anclote. Less people than Caladesi. Yes, tomorrow will be active.... but not crazy. Have fun.
  6. J

    Beaching at Caladesi, Honeymoon or Anclote

    Wife and I go to Anclote all the time. Bay News nine is showing an ENE wind with wind a little up at 15knots. Best bet for shelling is Anclote. With this wind go on the south west side. Watch low tide... anchor off shore.. wade in. Again, great for shelling. Three rooker bar and Caladesi are...
  7. J

    2007 240 SD Bravo III Forward Shift Delay

    Just to update to original post. I forgot. Had the cone clutch and gear assembly replaced. About $1700 in parts and $390 labor. Been a 100 hours now and all is good. Zero delay in shift engaging. Makes docking a whole lot less stressful!
  8. J

    205 5.0 fuel consumption

    You ran your boat at 50 mph for an hour and a half?? What were you taching? John
  9. J

    1 year old and tires worn out

    Most definitely you need to move the boat forward. There should be no boat overhang past the main support bunks.
  10. J

    Cool Fuel 3 IIII Raw Water Hose Fitting Repair Method

    Outstanding 'How to' !!! Thanks for taking your time to document the process so clearly.
  11. J

    Mounting upper half of magnetic closure transom swim ladder cover

    Yes it is. Then two screws are used to mount the ball assembly.
  12. J

    Mounting upper half of magnetic closure transom swim ladder cover

    Not sure of your model.... but my '07 240 Sundeck has a molded hockey size disc moounted to the under side of the cover. Then the magnetic ball mount is screwed to it.
  13. J

    240 Sundeck Thread - Questions and Answers

    My wife and I had the same issue with our 2007 240SunDeck. Very difficult to reach the single grab/tow bar especially in deep water, say above waist high. I installed a 12" grab bar just forward of the ladder hatch. Solved all problems. I attached two pix if they made it.
  14. J

    With the Good comes the Bad

    Not really. Many companies need to stop all activity of material movement to count things. Not saying it is the best business decision.
  15. J

    5.0MPI motor pull and oil pan question

    What would cause a 2007 oil pan to rust through?
  16. J

    240 Sundeck Thread - Questions and Answers

    Interesting reviews on the Attwood led nav lights. Not the greatest ratings. Corrosion and premature failure were noted.
  17. J

    WTF is up with this weather

    Why does one have to swear in a title?
  18. J

    Question....would you?

    I would not have spoken up.
  19. J

    Steering wheel with excessive play

    Sounds like the same problem my 2007 240 SunDeck had. The steering wheel would actually wobble around a bit. The center nut was checked and tight. The Tilt mechanism between the the wheel and the rack had to be replaced. Now tight as when I first bought her!
  20. J

    Help with ordering manifold kits/parts

    Sorry. Should have said 4 years.
Back
Top