I have a pair of CPUs with only 160 hrs of time they work perfect and are plug and play will test with any mechanic of your choice it's only one plug to install
i am almost positive they have multiple year applicationsn With the 350 mpi series engines but you can check they came out of my 02 03...
I am in the middle of a interior remodel as well and also a commercial gc
had my guy on board and says unless the air is on all the time in my Florida heat it wouldn't be a good ideal, however it might be a different story with low humidy in Tennessee I think I am going to go with the glue down...
Thank you for the trip info and pics I am born and raised in south fl and have never
traveled beyond the site of land let alone travel up the entire east coast!!
I noticed you departed from punta gorda I am selling am closing on a large corner lot in PGI
on Friday it's in the bird section it...
Re: 1990 44 aft cabin with cat 3208s need prop and general info please advise,, than
Thank you, I am surprised the rpm range is that hi for a 23000 lb boat,
i will pass that along to the prop shop,, is Ta mean its a turbo? If so yes the engines are turbo charged..
Thamk you..
Re: 1990 44 aft cabin with cat 3208s need prop and general info please advise,, than
Decided today we going to pitch prop down 2 degrees according to cat I should be 24 to 2800 w.o.t. Does any of the 42 to 44 aft guys with agree?
Thank you..
If any one cares I did find a place that stocks the the space maker Coffe makers that are new and no old used junk I was seeing on eBay.. Cosmicscoffe.com hope this helps anyone looking..
I noticed today that my 44 Ac stereo and speakers are all tied into the 120v system including speakers which are switched on the bridge .. So am I right in thinking if the generator is not running there will be no audio while under way ? I guess there will need to be another 12v stereo installed...
Hello looking for some help my 44 aft is not planing and I have decided to have props computer balanced and polished at frank and jimmys in ft Lauderdale does any one know the size and proper pitch for this boat and also my rpms and any vital information.
on sea trial she was trimmed fully down...
Just got back from a trip on my 320 had a couple of small beeps last trip Mecanic says
water pump I go for it and all is well for 2 hrs and on my way back down Iwc about 1500 rpm
same little beep jut for a couple of seconds and that's it... Always somethinq!!!!!
Any ideals? Thank you
This one of those things that is so easy but yet a nightmare,
my 1990 44 aft cabin which I am completing a interior remodel has a factory black and decker space maker can opener as well as a coffee maker built in which is filled with h20 from the front I have been looking for weeks to replace...
Thank you this makes the most sense and I agree to keep it simple
And not close the valve it makes sense the factory flush connects directly
to water pump forcing fresh water threw the system
Thanks everyone for the response.
Ted
This could be a dumb question but I have the quick connect flushFittings on my engines when flushing with fresh water Do I run the engines or not? Sorry seams stupid but when I do not Run engines I do not have any flow from the exhash from the port and starboard sides.. Also shouldn't the boat...
Hello
Will the canvas enclouser INCLUDING the front canvas as well the side cutains and arch section from a 2007 320 sundancer fit
on a 2003 320 it looks very close to me .. Thank you for your help..
TD