I will get you the info as soon as I get back up north where the pumps are. Pay Pal is fine and will save one for you. I might be up there next week and will get back to you.
I have 2 Sherwood water pumps ( Sherwood P1730 C) from Cummins 6CTA 8.3 engines that i replaced with the SMX water pumps. These would be a good spare for someone. They were working with no leaks. #150 each plus shipping from NY.
Chuck
716-316-3410
Used in very good condition a set of 22x26 Teignbridge 4 blade props. 2” shaft
Did have them prop scanned and were in spec. Looking at $1000 for the set plus shipping.
Chuck
716-316-3410
Get it replaced ASAP! I hit a log and took off my starboard side a few years back. I added boost and exhaust temp to my boat previous to this happening. Normal running temps were always around 850 and when the exhaust broke off it went to 1200. I hauled out as soon as I got home and with the...
A friend hit 2 of mine and bent them. I used a piece of heavy angle with a 1/2" threaded stock. Modified a stainless canvas frame mount that I had laying around. Held in place to the stanchion with 2 straps and just started turning the nut which pushed the tubing back in place. No heat was used...
I Have 1 that I purchased as a spare in case mine failed. It has the upgrade to be used with the newer C and E series Radar as well as yours. Give me a call or message me and we can work it out. I can check it on my boat to make sure it works before you commit to it. When I purchased my boat it...
Check the rollers and the track at the top of the door. The track is probably cracked causing the roller assemblies to bind when you open it. Happens a lot to these doors. Parts can be found at fpmarine.com
Looking for 2 - 5" Non working Searay tachs. If you replaced your tachs and have 2 of these laying around and want to sell for a reasonable cost send me a message. Just need the glass and housing to be in good condition.
Did you by any chance hit anything while running? I have in the past hit a log and even though everything appeared to be ok from that point on when i filled the fuel tanks 1 side would take 20 gallons more thank the other. Prior to that every top off was within 1 gallon. Sent the props out and...
I use a campells soup can. Find one that fits your pump cut the end off rotate it as you slide it in your pump to remove the old and reverse it for installing the new. Rotate to install the key and then slide it out with a slight push on the impeller to keep it in the pump. Cost basically free...
Found where I had to gain access to for the aft stanchion. Had to remove the mirror and can just barely reach the bolts. I also can remove the curved panel just aft of the mirror but would have to also remove an A/C junction box that's attached to it. Either way the mirror comes out first. Now...