I made them. I bought 2 long hard rubber boat trailer rollers (12") and cut it into 1" pieces. I think the inner hole was 1/2". So I bought 1/2" SS Tubing and cut the tube long enough to accommodate the width of 2 wheels + davit arm. Then I put SS washers and a SS bolt through them.
Hello, Post on the LED replacement is terrific. Helped me replace all lights except for 2 in the Head because I can't open them. I turn but nothing happens. How do you open them? I haven't replaced the rope lighting. You wrote: Rope Lights- 15 feet needed - need 3 dc to ribbon cable adaptors...
I want to update my radar arch and cockpit lights to use multicolor LED festoon bulbs. I'm thinking I need 4. Two in the Radar Arch, one starboard side at the helm and one port side under the sink.
I just remembered that when standing on the dock looking at the transom, I know I put the cockpit...
2000 310 DA w/ Inboards.
Anyone know the correct wiring for a SB replacement tach?
A friend took off 3 wires to stop the gauge from alarming for over Rev'ing. I replaced the gauge, but when I put the wires on where I thought they went, the engines cranks but won't start. When I remove them it...
Hello All,
How do you leave your air conditioning settings (in your slip at the marina, connected to shore power) when you're not on the boat and you wont be back until the following weekend?
Thanks
Art
I also have the 2000 310 with Vdrives. As stated the seakeeping characteristics are great. I've had the boat out in 8-10ft waves with the occasional 12 footer thrown at us (not by choice) but the boat handled it very well, I'm 6'1" and my wife and I sleep in the forward berth. We use a thick...
I just launched the boat and was testing out all systems.
When I turned on the AC panel breaker for the Air Conditioner, the Air conditioner went on. However; the SMXII control panel was reading 72 degrees in Heat Mode. The problem is that none of the buttons on the SMXII control are doing...
i use 1/2". I have never had an issue. 5/8 are too big for the cleats on my 2000 310. The cleats were smaller back than. They changed them in 2001.
I have the same slip config 4 poles and a finger pier. Use 6 lines.
Starting from the forward most poles as bow lines. My poles are almost even...
I am the 2017 Commander for the Great South Bay Power Squadron. I will be happy to put you in touch with a Power Squadron in your area. Just let me know you are interested.
That is a quite ambitious / dangerous trip in a 19' bow rider. I wouldn't do it. Are you talking about being in the ocean going around Coney Island, under the Verrazano Bridge and past lower Manhattan. Circle Manhattan and then back around Coney Island or are you going up and down the LI Sound...
The strakes or stabilizer fins are circled in this drawing. They are 20" long and stick up 2". They are hard rubber. I think they will get snagged trying to slide up over them...
What you can't see from those pics is that the redesign now has a slot for a fishing pliers, a knife and a a small cheap cutting board in the center (that is replaceable), but I don't like to cut any messy bait on it. I have no cockpit carpeting or transom bench when fishing. I tie down a cooler...