Search results

I'm replacing the R80RC original to my 410DA with a C120. I'm sure I'll be back with wiring questions after getting the C120 and new radar pedestal installed, but I'm stuck at square one. I'm trying to remove the R80 and can reach the near side after dropping the dash panel, but can't reach the...

I shared a couple of thoughts on this topic with Dominic and he suggested I post it here and see if I can pick up some ideas. Looking for a check on my thinking – hope you can help. I am adding the dual boost (2”) and dual EGT (3”) from Tim at Designated Engineer. Challenge is to figure out...

After looking for nearly a year (and lurking on this forum most of that time) I'm headed out tomorrow to pick up a 2000 410DA with CAT 3126 (385) power. Completed CVS and engine survey and all came back clean - sticky stbd tach, bad lamp in spotlight, small gouge in gelcoat at bow, air filters...