Search results

  1. BurleyCove

    Sold my Sea Ray for a Cruisers --- Am I kicked out ?

    Sold my 94 290 SD for a 2009 Cruisers 330 Express. Does this get me kicked out of the Sea Ray forum? :grin:
  2. BurleyCove

    C 80 Linearization issue

    I was trying to help a buddy fix an issue with his C 80 and got stumped. The display shows the vessel icon about 180 deg off. We tried to go thru the linearization steps in the manual and the system would never complete the process Looked for any potential magnetic or metal interference and...
  3. BurleyCove

    backfires and stops

    Changed the plugs, dist caps and rotors on both motors. started them up after each step and checked that the motors were running fine. They purred like kittens even up to 3000 RPM, As I was just letting both idle for a few minutes before cleaning up, the starboard motor backfired and...
  4. BurleyCove

    Have no Fear

    By this time next year the climate change enthusiasts will have produced a lot of data that says this year was the warmest year on record. Now if the thermometer would only agree with all of their data.:grin:
  5. BurleyCove

    How much pink does it take

    I used muffs to run pink into the motors today, First ran salt away thru them and then connceted the pink. It took about 4 gallons per motor. Does that sound like the right amout for a 4.3L?
  6. BurleyCove

    What wattage light bulb meets the 2 mile visibility limit for a white light?

    Seems like a silly question. My boat has the pole that attaches to the top of the windshield with the white nav light that has a forward FOV and an additional light with a aft FOV for anchoring. one bulb burned out so I thought it would be smart to replace both. The only bulbs at the store...
  7. BurleyCove

    Adjusting mixture on carbs

    I had the carbs on my motors rebuilt and they are running great. I worry I stil have is that when I stop to hang out on the hook for a while I get a whiff of fuel. I'm guessing that maybe the rebuilt carbs are running a little rich. I did not adjust the mixture screws when i installed the...
  8. BurleyCove

    whats the best product for lubing the canvas ziippers

    theyre getting a little sticky and was just wondering what others use. Its another newbie question
  9. BurleyCove

    4.3 LX stalls under load

    Srange problem. My port motor runs fine at idle. (starboard too but thats not the point) when I accelreate to get on plane the port motor stalls and then quits. it wont re start until it cools off. seems flooded, I replaced coil, plugs, wires cap,etc. No differenrce. any other ideas...
Back
Top