Search results

It’s a crossover switch. If your battery is not fully charged, it will enable you to use the battery from the other engine to start the engine with the weak battery Just hold down the triangle switch while starting the engine

I’m sorry I meant 110ac outlets I was able to easily add a 12v receptacle on the electric panel in the cabin Marinco makes them and also has usb receptical options They’re available from Amazon Sorry for my mistake

There should be 12v outlets in the forward bunk area on starboard side just into starboard cabinet Another in the cabin under the port hole in the head Another by the stereo cabinet close to the floor by the aft bunk And another in the cabinet by the stove in the galley

I had the same issue. It turned out to be a bent rail, which probably happened if someone stood or jumped on the bench without having the support leg extended down to the deck. My sea ray dealer hooked me up with the part manufacturer and I replaced the rail. Somewhat of a PITA to do. Bolts...

1/2” rope, 1/4” chain

I’ve had a few problems with the windlass. The box that you hear the clicking is the relay It serves two functions, it allows a control switch (such as your dash or foot switch) to turn on a high amp circuit that controls the windlass motor It also switches polarity going to the motor which...

I'm having issues with a cabin leak that I thought I fixed some time ago by tightening the forward starboard port hole latches. I heard it's a common problem with the boat. Mine is a 2003 280DA. Has anyone removed a port hole and resealed it? Did that correct the problem. The water is soaking...

I have had an issue with the smell of fuel there. I needed to change the washers on the gas guage sending unit it solved my problem the access panel is in the middleof the aft berth

Thanks for everyone's input! I'll give it a try, thanks again!

Does anyone have photos or could anyone explain how to remove stern back rest for re-upholstery? Are the bolts behind the port and starboard dividers in the stern storage compartment?

Has anyone replaced the rail for the port lounge chair? If so, how did you remove the old rail?

Woody, Here are photos of the access hole and sending unit

Has anyone had a problem with the port lounge chair track? Mine is binding and may need a replacement. Any suggestions?

Re: Official 280 Sundancer Thread - Odor of Gas under cabin step It turned out to be the gaskets for the screws holding the sending unit in place that had broken down. I changed the main gasket also. It took about 24 hrs of using a blower into the inspection hole to evacuate all the odor of...

Re: Official 280 Sundancer Thread - Odor of gas under cabin step Has anyone had a problem with gasoline odors under the cabin step I think my issue is possibly a leaking gasket for the fuel sender under the aft bunk

Thanks for your help, I'll give it a try!

Does anyone know how to remove the stern backrest on a 2003 280 DA? I need to get it reupholstered.

Has anyone had a problem with low engine temperature? I recently got into the shallows and sucked up some sand. The engine began running with a low temp it turned out some sand was keeping the thermostat open I cleaned it out and is good as new i hope this can help someone else with the same...

Thanks!

Has anyone replaced their engine hatch hydraulic cylinder assists? If so where did you find the replacement cylinders? I have the 2003 280DA, without the motor assist, it' manually operated. Thanks!