It checked out ok, I think the new grate on the thruhull is too small causing the flow rate to slow down just enough. It is is icing up when left on automatic mode. if I keep the fan on med speed its enough to keep it from icing up. All vents are clean and the air filter is clean. I think the...
I called Mercruiser tech support and they where very helpful, they gave me the location of the wire in the harness, they also suggestion and told me how to reset all the sensors. I guess with v-drives, it uses the same harness for the rudder angle sensor. My rudder angle sensor was working fine...
I called Mercruiser tech support and they where very helpful, they gave me the location of the wire in the harness, they also suggestion and told me how to reset all the sensors. I guess with v-drives, it uses the same harness for the rudder angle sensor. My rudder angle sensor was working fine...
yes, I do have the wheel and I clean the paddle wheel every year and it usually stops reading by July, I don't believe that could be causing the alarm.
So my vessel view says that my pitot sensor pressure is low. I have 6.2l Horizon engines with v-drives. I didn't think my boat had a pitot sensor, I thought only I/O's had them! I was thinking there must be a plug at the end of a harness somewhere with some water in it. Any ideas?
Cross posted
The problem is it is coming up as a alarm on vessel view, not just in a scan. I have the scan tool, and tried to erase it and it will not erase, so I think it is a constant fault.
So my vessel view says that my pitot sensor pressure is low. I have 6.2l Horizon engines with v-drives. I didn't think my boat had a pitot sensor, I thought only I/O's had them! I was thinking there must be a plug at the end of a harness somewhere with some water in it. Any ideas?
I have fresh water getting into the compartment under the steps, it is not coming from the shower sump box, and ideas? It happens when we use the shower but the box isn't leaking, it doesn't show up until the next day, I clean it up and it remains dry until I run the boat, then a little bit more...
My vessel view has a constant alarm that says "throttle control", it only happens when the engines are running and in neutral. The boat will go into both forward and reverse and turn the props, I can also rev the engine up in neutral and alarm goes off. I also turned off. It's batteries and...
I found one, Ocean Options in Tiverton RI, they are the ones that service most boat yards on Cape. I was able to pull the unit and drop it off saving me a considerable amount of money.
Can Anyone with a Koehler genset tell me if they have a grate on the bottom of the thruhull. If yes is it cupped like the ac one. I don't have one and want to add one, I sucked up some seaweed on the hook last summer and had a terrible night with no ac. I Am worried that the cupped one may...
Yes, and on the new models with the wood floor, its still carpet right on the edge, the wood doesn't go all the way to the edge, I am planning on finishing it the same way or using a piece of trim to cover the end, I haven't decided yet. I am looking at two products Amitco and Nautikflor. I was...
Mancave, I tried that, I even used a hose from the water dock and dove under and put a long screw driver through and nothing worked. When we got back to our slip the next afternoon it was all gone. So I guess getting on plane cleaned it out.
Can Anyone with a Koehler genset tell me if they have a grate on the bottom of the thruhull. If yes is it cupped like the ac one. I don't have one and want to add one, I sucked up some seaweed on the hook last summer and had a terrible night with no ac. I Am worried that the cupped one may...