my windless seems to not have much power. Pulling up it struggled not under a big load and then stopped. Motor wasn’t hot amd solenoid just clicked. Waited a few minutes and finished bringing it up. Ideas on 1/2 power and stopping half way?? Thanks!
Season winding down and I have an 04 with smart craft. SC says I have 3 gallons of fuel left. I was wondering how accurate these are and if it’s like a car with reserve and I actually have around 10 gallons in which I think I do actually. I was gonna test it and bring a 5 gallon container but...
I am looking at the new complete kits: Quicksilver number
817275Q05 and I am seeing they went back to the 3 seperate plate/gasket pieces and don't have the single molded plate gasket anymore. Is that true or are the kits I am looking at older stock items?? The last kits I bought had the...
Does the empty light go out once it fills up? If so I thought mine was the same way and it just was that I emptied it before it got to 1/2 full. The tank looks almost full and 1/2 just lite up so that could be your issue. Your just pumping it out too soon.
Sent from my iPhone using Tapatalk
2 battery ?? 1-if battery switches are off what bank runs fridge if selected on the main panel? Does the charger charge all 3? If one is low does it charge that one and trickle the others?
Sent from my iPhone using Tapatalk
That's what I did. I ordered 2 more iac's from rockauto and oem gaskets. I changed the mufflers prior to launch may 1st
Sent from my iPhone using Tapatalk
Anyone use the IAC from rock auto part AC423? Just wondering if anyone used the gasket that came with it as it's different then the flat oem one.
Sent from my iPhone using Tapatalk
I had my 1st IAC issue. Alarm sounded when running home but seemed fine. I put into neutral opened that hatch and all
Seemed fine. I got back to marina and when I put into neutral it stalled. I then knew it was the IAC so I started engine in Neutral with some throttle so it stays running and...
Engines/drives allset and painted just have to clean buff and wax and fuel up. May 1st at 930 for me. What about the 1/2 system? Good for resell.
Sent from my iPhone using Tapatalk
What size drill bit? Did you use heli coil or just drilled hole and used 10/32 to make new threads and then longer 10/32 bolts. Can you drill deeper on the trim cylinders? Wouldn't want to drill to far. Who knows if trim fluid is close by. Lol
Sent from my iPhone using Tapatalk
One of my alpha trim anodes is stripped so I took the washer off and grabbed that 1 thread and lock tite but I'll grab the 10/32 tap and make some fresh threads. Should be same size as prop carrier anode.
Sent from my iPhone using Tapatalk