Ryan, thanks man,i will be off this morning i might go for sea trail i will keep you informed BTW i have checked the fuel filter as i stated befor i found them really clean and i replace them just to insure its not the cause. anyway will see tomorrow
Harib
Do you remember the problem with the fuel I have told you about?
I have changed the fuel filters problem still exist so I was looking closely to the carburetor guess what I have seen this part actually not attached at all
I have attached it and everything seems to be fine. I need to go for sea...
I was planning to check and change the fuel filters as John advised me but guess what?:smt119 Engine room full of oil grease stains also some corrosion stain here and there. You know what you can say it is a mess:smt089.
I start cleaning it man it toke me three hours almost none stop:smt021.
I...
Guyz,
This info helps me big time. John, don’t worry about the spill and fume they knew am in the fire service so they always disappear. I will ship you but you should tell me how many gallons you are looking for shipping is expensive. I should take some rest to be ready early morning for this...
John,
am at work at the moment but nothing to do. am working in the fire service so just waiting for a call to be busy like you :smt101.
Now my fuel tank are totally empty as I stated above, I will put two can of gas dryer as your recommendation but I guess I should full the tank right?
if...
John you’re the man,
I was thinking to change the carburetor kit but after your advice I will change the filters first and then will see if its work.
Our gas is much better :thumbsup:you know why :grin: kidding
thanks a lot
Yesterday I brought my boat form the border to the marina which it was almost 4 hours cruising. Unfortunately I was not able to snap some pics due to what I have faced.
After I left the border approximately 15 mints, I start to notice some unusual sounds from one of the engine its just like a...
John,
you have done an amazing job :smt038 I saw the gallery and what you have done is encouraged me to do the same. well done man and thanks for the advice
I will post pics of my boat just like you’ve done (before and after).
TXVR6, I will post pics of my boat and the work I am planning to...
Sounds scary when you saied (not to burn the Gelcoat) I will do my best if this is going to work cuz my boat looks great except the color problem I have mentioned hope it worth the efforts.
Thanks for the tips body
Guys, my boat is an old boat and due to the sun exposure the color of the fiberglass turned little yellow. The boat is not painted, it is the original color.
I really don’t like the idea of painting it. Do you think there is any way I can restore the original color or even close too? I have...
Hi guys,
You might find this article helpful if you have some aluminum parts need to be polished. :thumbsup:
http://www.trailerboats.com/output.cfm?id=1151551§ionid=317
Thank you guyz for te reply.
sounds great Jhon, i just find the same detector you have maintained. i think the on channel gasoline detector will do the job since i dont have a separate engine compartment is that right?
like (Xintex 1-Channel Gasoline Fume Detector. The M-1)
Guys, I am planning to buy a new Fume detector. The detector I have is really old and I don’t think its still working.
Any idea which detector I should replaced the old one with?