Search results

  1. A

    Trim Gauge Wiring

    When I bought my boat (1980 SRV190, Merc 470) the trim pump was not installed. Now it is, but I'm not sure where the other wire for the trim gauge connects. One wire (of the black double wire) goes to the sensor, and the other ends near the trim pump, but I don't have anything that shows which...
  2. A

    78' SRV 190, What should I pay???

    I recently bought a 1980 SRV 190 with a Merc 470 for $1150. The trailer is 1996 model, and looks nearly new. The engine did not run when I bought it (bad idea, I know) but we were able to crank it over. Over all the boat was in very good original condition, and the only thing missing was the...
  3. A

    Maiden Voyage

    I purchased this boat as a non-running project mid-May, and have spent a lot of hours researching, troubleshooting, and repairing. I took it to the lake for the first time yesterday morning, with my 15 yr old son, and a neighbor friend. The boat ran well for our first test on the open water. I...
  4. A

    Mercruiser exhaust baffle installation- any tricks?

    Attemping to install a new exhaust hose on my 1980 MC-1 lower unit. I managed to get the hose mounted on the transom side, but the lower unit side is pretty tough to wrangle. Does anyone know of a trick to make this a little easier? Thanks, Greg
  5. A

    1980 sr v190

    We just purchased this 17 ft. SR V190 last week. It is all original, and complete. Very good condition for the age. Getting it cleaned up, and ready to go in the water.
Back
Top