Has anyone changed the stereo speaker amps behind the breaker panel. I have 2 small ones and i believe one is not working. My starboard arch speaker and sub have failed. I've switched out the arch speakers, they are both good. I've checked all the stereo head fuses that i can find. My thought is...
Does anyone know the amp locations for the helm seat woofer and the arch speakers for my 07 380? Its all original.
Im guessing behind the breaker panel, its the only place I haven't looked.
Also, does this breaker panel flip out without taking the panel door off? It doesn't look like it has...
I replaced that same light this year, cut the wires to remove, bought a larger led light to replace, lots of light in the panel now. I waited so long to replace I forgot it was step lights that turned it on.
Anyone have any info on the light inside the breaker panel box, in the cabin (2007). I thought my bulb was just out, but it turns out the wires dont have power and I'm not sure what switched it on. Panel door? Or the step light switch? etc..
I was just going to put new led fixture in but i have...
I had similar problem last month when restarting my ac pump. After trying all the above remedies, it turned out that my pump needed to be cleaned out. It had black river muck that was causing the problems. I do remember last year having some really low tides at our marina. Now I have flow better...
I had the same happen to me 2012 for unknown reason. This shaft problem has occurred to several boats in my marina, all different sizes, but all 8.1's and similar size shafts in the 04-07 time frame. Try contacting Searay.
I had to cut my rope from my anchor chain/rope. I recovered all, I just need to find somewhere near DC, NOVA/md to splice my line again. I have everything off the boat but having trouble finding a rig shop or someone to do it. Any ideas?
Any chance it could have been a shaft failure? It bothers me that that I didn't hear anything before alarm went off ( high rpm). Never saw anything in water after slowing. It happened at 3500 rpm. These are not original shafts and props, a previous owner went aground but all was replaced by...
I hit something that was submerged, never saw it. No loud noise, no vibrations. But that's because It sheared the prop right off the shaft. It nicked the underside slightly, but other than that, seems no other damage. Any advice on how to handle the insurance. I guess I have to see how much...
Hi all, I was wondering if anyone else has had any stress crack problems with the arch of the hardtop. Mine seem to come from around the speakers installed on the inside of the arch. Its happened on both sides. I've noticed the 40's have big support braces in the helm area supporting their...
I had a salesman tell me to always run my generator when going out for the fridge and ac. One impeller later, I was wondering if just running the fridge would Be ok on engine power. Any harm to anything? I don't need the ac on most outings but I'd like to keep the fridge cold. Do I need to...
Any luck with the error 62 code. I just had this problem, 24 hrs on kohler. When I docked, it restarted manually from the unit had good flow and ran well. No strainer issues. Code isn't in the book for some reason.
Hope u found a solution.
Thanks for the great info and help with the tabs.
The A/c unit in cabinet sits in/on a tray/pan. This has a drain tube on it. This pan/tray had the crack that leaked water into cabinet and aft sleeping area. Dealer taking care of it. Just one of those things i guess.
Near the end of the hose (head) is a section thats rotates for an additional way to turn water on/off when holding the hose. I missed it also we checking to see if it works.
Hello all, I've put a few hours on the 2010 and had a few minor issues and questions.
1. The v berth table didn't fit at all (had 270da sticker), but dealer reinforced the cross bars and made some adj and now works as intended. Looked like Searay wasn't sending updated version.
2. A/C...