I would like to get advise on how to mount a dingy on the swim platform of a 1996 Sedan Bridge 400. If anyone has done this and has photos, that would be great.
I pulled the transducer out and replaced with the plug. Barely any water came in (I was expecting the worst). No paint on it, so .... something is broke, any help on this issue would be appreciated. I have Smart view but it runs through the SR Navigator. Everything on the plotter is working fine.
I cannot see much of the wire lead as it goes into the bulkhead shortly after leaving the transducer. It is possible (but not likely) that anti-fouling paint got on the transducer, would this impact the reading? The wire lead has AIRMAR C189-02 , C1225 on it. I also checked the wire going into...
I have a 2004 Sea ray 390 DA. It has the Sea Ray Navigator plotter. My transducer has stopped working for depth.
Any one know the model number of the transducer? Any ideas what to check to try get it going?
I have twin QSB 380's in our 2004 Sundancer 390. When started up for the first time today, there was a loud squealing sound from the port side, sounded like a belt. I guested something was seized.I went into bilge with a light and fired up engine again to see what was stuck, but it fired up and...
Take the hinge off and go to Home Depot. Match it against a seat in stock.
Buy the whole seat for the hinge. To buy the proper hinge for the original cover will cost big $$$.
A bow thruster is all you would need, if anything. Even then, when you get used to the boat, the thruster would only be required if it was very windy when you were docking.
Zinc will still work in Fresh water. Magnesium is higher on the galvanic scale than zinc however. Read the attached information on Galvanic Scale.
http://corrosion-doctors.org/Definitions/galvanic-series.htm
Essentially the higher an element is on the galvanic scale, the more readily it will...
PM me your email address and I will email it to you. I messed around with the amps and lots of other stuff. Turned out I just had to hit 4 buttons on stereo to reset. Manual doesn't tell you that if the power is off for extended period (dead battery or unhooked battery) you have to reset.
I had a problem with our Clarion XMD3 where the cockpit speakers stopped working. As it turned out our shore power had been disconnected and our batteries were dead. The problem with the speakers happened after that. When I asked on this forum I got the fix, it was a reset on the stereo.
Service...
I will pass on the advice. I advised him to get rebuild kits, duck bills etc since it is not east to get at, change them while he has the chance.
Anyone know the model of the pump?
A friend has a 1996 sedan bridge 400. Yesterday his toilet would through the breaker when he flushed. Any ideas on what would cause this? Anyone know the pump make and model?
Great Thread.
Anyone know where to get the part number of the Bearing?
My manual (2004 39 DA with 1.75 shaft) has the strut part number (1617992) but not the bearing number (or OD).