Search results

How can I check that?

Tom/Linda, I did switch gauges and the same happens on the port side. The gauge went almost 2 months after the oil change. Connections are this.... Port Side = 4 purple wires lower left post, 2 blue wires lower right post and 2 black wires in center Stbd Side = 2 purple wires lower left...

Hi Steve, As soon as I start the engine, it goes to 80 and stays there (at all speeds) until I shut down. The oil was changed on April 22nd (both engines) 10-40 oil. Oil level is full on both dipsticks. Oil looks clean. Stbd. engine shows 40 psi at idle and 42 at high speeds. Jim

My 12 year old port side oil pressure gauge went to ZERO. I replaced it with a new gauge that went to 80 psi when I started the engine. So, I replaced the Sender and it still went to 80 psi. I decided to switch gauges with the stardboard gauge and it still went to 80 psi. So, the gauges work...

Recently, I lost my port engine due to a coil failure. I could not steer the boat with only the starboard engine, so I called Sea Tow to come to the rescue. When a new coil was installed, I went out on the water and put the starboard engine in neutral to simulate a dead engine and could drive...