Hi . My port4 in 1 gauge died. I need to replace it p/n 1040905 . No seems to have it. All that I find are smart craft , is there a way to connect the smart craft to the nine smart craft gauge????
hi , my gimbal on port engine is leaking. its an alpha1 gen 2 . how do I know were is beat to order and if its a gen 2 does the year matter???? would greatly appreciate your help. thanks mike
Hi my 02 sundancer has a kolher 5k model 5e generator. Lately when I shut it off after a few hours of use. It will turn on by itself??? Even if I shut of the gene and shoreline switch.. Has anyone had this issue????
Hi, my trim connector block went bad, my question is when I removed the cover. Instead of a zinc plate it has a plastic cover with a sensor on it. 2 wires run thru the hose connector into the gimbal. Can I cut the wires and eliminate that sensor? And or what is that sensor for?:huh:
It's been 1 year since I repaired my holding tank and it is still holding perfectly. Again I drilled out the bottom nuts, where the leak was coming from with a 1 inch hole cutter ,then I installed a 1 inch seacock plug ( twist on) applied marine tech and inserted them in the 1 inch holes I...
hi. need help with smartcraft gauges. this is on a 2006 300 sundancer.I cant get the depth finder to work on my gauges. it use to show on the starboard gauge. I reset the three gauges and it doesn't work any more , it shows them trim but not the depth finder. when I reset the gauges . I set the...
hi. need help with my smart craft gauges.I use to be able to see my depth on the starboard gauge display.nd know it doesn't work. I pressed the reset on all three gauges and it disappeared. when they reset. it asked . which engine port or starboard I set the starboard first. it asked for...
Good morning . Does anyone know if there is a breaker or fuse for the water pump for the a/c unit. I turned the a/c on and there is no water coming out of the pee hole. I don't see anything but the main breaker for the unit?
Alex got it right. I used a 1 inch hole saw and cut out the embedded nuts under the tank. Then inserted a 1inch rubber bilge plug . Sealed it with marine tech . I cut off the t-handle of the plug and used a rubber mat to give clearance to the remaining stud from the plugs , so they would not...