Search results

  1. D

    Prop cavitation

    Hi all When returning from my last outing in fairly sloppy conditions I noticed we had distinct prop cavitation at low speed. With the drive right in the existing 141/4 x 17p 4 blade was loosing "bite" and would slip with higher rpm and see no increase in speed. I was told once that my existing...
  2. D

    Do I need riser extensions?

    Hi everyone As the title states I am curious if I need riser extensions as I have just replaced an engine due to water ingestion and cannot rule out the possibility that the swim platform with people sitting on it effects the water level in the "y" pipe whilst not underway. Thanks in advance...
  3. D

    Crusader engine question

    Hello Could someone please confirm if crusader still make a carb 350 engine and if so do they require a through hull water feed on full closed cooling? Also would any dealers ship to Australia? Thanks Darylle
  4. D

    Alpha 1 gen 2 gimble housing mod

    Hello A question regarding filling in the void/cavity where the trim/tilt hoses pass into the lower section of the G/housing, below the Y pipe. Upon removal of our 20 year old unit I discovered that once water collects in this area it is permanently trapped and gradually corrodes the internal...
  5. D

    Fuel tank removal '94 230 DA

    Hi again I am after some feedback regarding the removal of the fuel tank in our 230 DA The engine is currently out to replace a leaking Y pipe and while it is out I thought I might remove and check the tank. Thanks in advance.
  6. D

    4.3 mpi vs 5.0 carb

    Hi Searay fans I am looking to update our 1994 230 DA 5.0 carb engine and am considering the 4.3 efi v6 could anyone provide any pro's or con's for this option. Thanks in advance Darylle
  7. D

    Canopy/clear clips.

    Hi everyone I am currently in the process of a canopy rebuild and was wondering if there are any other options for attaching the front and sides of the front clears to the screen frame. I am trying to avoid press studs and zippers. Any suggestions would be much appreciated and yes I have tried...
Back
Top