Search results

Great, thanks for confirming. This is really good for people to know and I assume is somewhat of a known issue with Garmin. They almost always have you try "something" when you call but the reaction was almost immediately "move on". I found the most confusing part of the install (by far) was the...

Hi, I'm in the process of installing a Garmin AP now. The steering and pump respond perfectly but I too cannot get the pump stall error on either side. I've bled (using the wheel and port/starboard buttons in the dockside wizard at least 50 times). I called Garmin and they suggested just moving...

Dan, i just posted a video on YouTube, do a search on Powerwinch 603. Bob

Thanks guys, I'll check out the link and post back if I wind up doing the job. BTW, Rust-oleum sells a clear spray sealant at HD which I use do my shower at home. I'm sure it the same stuff.... Bob

Guys, I'm posting from the dark side as a Trojan International (1988) owner. We share a lot of common parts so I do spend some time here. Since there a lot more "you" than "us" I thought I would ask: - I want to replace the windshield rubber trim which is made by Taylor Made. I have a sample...

Brand new Perko (chrome over brass) deckplate. Never installed, wrong size for me. For 1.25" hose, 3 1/8" wide at the flange (top). $40 shipped to lower 48. Bob

Brand new, never installed Airmar thru hull transducer. Still in the box with everything you see including instructions. Don't make the same mistake I did and get the wrong one. This is a B774v but there are different versions. This is rev #31-289-1 (on the white tag) with a small round 7 pin...

This is a Signet P80 unit which displays temp, depth and speed. Signet is still in business and tranducers are still available. Previous owner disconnected and installed new. Old transducer was clearly the issue (underwater damage) but he didn't do any troubleshooting. I have no way to test...

Brand new 3 1/8" Shield Exhaust hose. I needed 3" and already threw out my old hose. I had to cut one section and use to winterize. Cut piece has never had anything but anti-freeze. Total of 12' @ $23.49 a foot at Lighthouse Marine. "ShieldFlex II with wire" $190 includes shipping included...

I have a pair of basically new (less than 20 hours) Flo Ezy 238 micron filters. These are recommended by Flo-scan to be used BEFORE the floscan sensor. This will also eliminate the need for a pulsation dampner. Filters are red/aluminum and have a cleanable screen which can easily be done on...