Search results

  1. MikeT

    Chesapeake Bay Cruising

    Thanks for the responses. I will check them out.
  2. MikeT

    Chesapeake Bay Cruising

    I am considering moving my boat to the bay for a few months(May, June, July) next summer for some extended cruising trips. Looking for recommendations for marinas in the Norfolk/Virginia Beach area to use as our base. We will be 5-6 hours away from the boat so would like a well protected...
  3. MikeT

    Official 380 Thread

    Thanks for the responses. I didn't realize there was a GFI behind that door. Will check it out this weekend when back at the boat. I knew of the one in the head and in the cabinet on the starboard side. Are there any others I am missing?
  4. MikeT

    Official 380 Thread

    The receptacles in the galley are not working. The galley systems breaker on the distribution panel is on, GFI's not tripped. Is there something simple I am missing? Thanks
  5. MikeT

    AC Trigger Realys 2003 380DA

    Thanks. Found them behind the vertical seat cushion of the couch.
  6. MikeT

    AC Trigger Realys 2003 380DA

    My forward AC unit will not trigger the AC pump, so thinking I have a bad relay. Does anyone know where these are located? Thanks,
  7. MikeT

    No water from shower head

    Thanks for all the replies. I have water up to the miving valve so must be something inside there. However, for the life of me I cannot figure out where the set screw is to pull the handle off to get inside. It is a Grohe. Looking online now to see if I can find a schematic.
  8. MikeT

    No water from shower head

    Open
  9. MikeT

    No water from shower head

    I have water coming out of every faucet except the shower in the head. It is same using dockside water or the boat's water tank. Any ideas?
  10. MikeT

    Official 380 Thread

    I have a 2003 380 with the RL80C radar w/ open array. I need to remove the radar off the arch for Hwy transport. Can anyone provide some direction on the best way to do that? Thanks
  11. MikeT

    8.1 motor won't go over 1000 RPM

    I just had the same issue. However the alarm (EMCT) went off before I even started the engine. My problem is when I went to unscrew the old sensor the nut basically broke right off with most of the sensor still threaded in the manifold. Any ideas on the best wat to get it out? I thougth it...
  12. MikeT

    AC question 380 Sundancer

    Update...Turns out I sucked up some mud and clogged the lines on the front unit. I hadn't expected that as water was flowing through the salon unit. I guess since the front unit was the only one running there was more pressure to pull it through? The unit should have shut down and given an error...
  13. MikeT

    AC question 380 Sundancer

    The unit was in heat mode and the salon unit was not running. I usually leave one unit on at 58 to 60 when I am gone. Didn't think the water temp had gotten that cold but could be wrong.
  14. MikeT

    AC question 380 Sundancer

    Got to the boat this weekend and noticed the the forward AC was not pumping water. It was the only one running, water was flowing through the salon AC discharge. When I looked at the AC it was a block of ice. The water lines around the coil were totally covered, looked like the compressor sat in...
  15. MikeT

    Places to Go

    I wanted to see if anyone familiar with the Wilmington, Southport (North Carolina) area might recommend some things to do, places to go besides the obvious. Looking for resturaunts, anchorages where you can swim, or any other suggestions. Our boat is currently at the South Harbor Village Marina...
  16. MikeT

    TV in 380DA

    Thanks for the help guys. It was the GFI in the head. I just couldn't find it on the first try. It is up under the vanity, hard to find if you don't know where to look. Everything working now. Thanks,
  17. MikeT

    TV in 380DA

    I just purchased a 2003 380 Sundancer. I just picked up the boat this weekend and the TV in the main cabin over the frige will not come on. It worked during the survey but now seems no power to it. I checked all breakers and everything else on that side, fridge, microwave, coffee maker is...
  18. MikeT

    New Member

    Survey went well. Nothing major to report only minor stuff: As far as the engine surveys, the mechanic said it was the first boat he has done where the only recommendations was service the engines (oil change, plugs, impellers, belts) mainly to give me a starting point. The compressions...
  19. MikeT

    380 Sundancer Survey

    I have an offer in on a 2003 380 DA with 8.1 Mercruisers. THe survey is sheduled for this Fri (Nov 2). The boat looks in good shape and appears to be well taken care of. I was curious if anyone knew of any problems with this year/model or any general advice on some things I should look for...
  20. MikeT

    New Member

    Hello from Denver, NC. We are in the process of purchasing our first Sea Ray, a 2003 380DA. The survey is scheduled for Friday, Nov 2nd, hopefully all goes well. The boat will be kept at South Harbor Village in Southport, NC. Just happened to stumble accross this site, looks like alot of...
Back
Top