Search results

Anyone have any idea where I might be able to get a left side dash switch panel bezel for my 2005 340? Mine evidently was super brittle and broke in several spots. Tried flounder pounder, marine max and technographic. The switch pad itself is fine.

I seem to be having an issue with my rpm’s being off to each other. I changed the spark plugs and it didn’t help. My port motor is definitely lower than the starboard. I’m not having any vibrations. Any ideas? 2005 sundancer 340 with twin 8.1’s. Thanks!

So I’ve been getting this alarm go off either when I go to take off and throttle up or yesterday it happened when I was throttling down. It always stops and I’m able to continue. I thought the problem might be impellers so I changed them. Still happening. It’s an audible alarm on my system’s...

Anyone know where the power vent motor for the galley and head is located? Mine stopped working. How hard is it to get to and replace? Thanks

How long should I expect to get out of my manifolds? I'm in saltwater in SW Florida. I have a 2005 340 Sundancer with 8.1's Thanks for the input

I have a 2005 340 Sundancer. Has anyone added an auto pilot? Is this something that can be done yourself or is it better to hire a professional? Also, what is the average cost with install? Thanks!

I started the generator last weekend and noticed it was loud and not pumping water. I ordered a new impeller and installed yesterday. I don’t use the generator a lot and had just changed the impeller about 7 months ago. After I replaced I noticed the way it sits in there doesn’t look right. It’s...

I have a 2005 340 Sundancer. Has anyone replaced the rollers on the cabin slider door? Trying to find out what size the trucks (rollers) are. They have them at boatoutfitters.com but have different heights. Thanks

I’ve been getting an alarm every once in a while. Sounds like the noise the generator battery switch makes before you start the generator. Anybody know what else causes that alarm? I’ve noticed it while we’re at the dock on shore power. I can’t really tell where it’s coming from but doesn’t...

We were using the boat yesterday and when the time came to leave my right side batteries were dead. I knew I needed to replace them so I wasn’t too concerned. I jumped it using the switch and they started no problem. As we were leaving I smelled smoke so I stopped the boat and looked in the...

My ac has been shutting off at the thermostat. Doesn’t trip the breaker and there’s a good stream of water flowing. I cleaned the filter. When it goes “out”, all that’s displayed is the temperature. Anyone have any ideas on this? Thanks

Hey guys! I may have posted this in the wrong forum yesterday. I know there are several threads on here about this but I can’t seem to find what I’m looking for. My vent window on my 2005 340 stopped working the other day. All I hear is clicking. Took it apart and screwed the actuator in to a...

Hey guys! I know there are several threads on here about this but I can’t seem to find what I’m looking for. My vent window on my 2005 340 stopped working the other day. All I hear is clicking. Took it apart and screwed the actuator in to a closed position. I wired a drill battery to it and it...

Hey guys! I've got a 2005 340 Sundancer with 8.1's. I had a pitot warning come on on my vessel view a while ago. I had a mechanic come out and look at it and he said I didn't have a pitot so he called mercruiser and I thought disabled it from the vessel view. Everything was fine until last...

Anyone happen to know the torque specs for manifold bolts and elbows on a 8.1 horizon? I'm finding anywhere from 15-25 on the elbows to 25-30 on the manifolds. Thanks

I have a 2005 Sundancer 340. Looking to install a flush kit on the motors. Has anyone done this? If so, do you run a water hose into the engine room every time or do you have a hose connection somewhere a little more convenient like the rear fender/dockline compartment? The one I'm looking at...

Anybody know what pitot ckt lo means on the smart craft vessel view? I changed the oil and fuel filters in both motors. When I got done, I was getting that error code. I think it has something to do with the water pressure because they're off from motor to motor. Left is running in the 3's and...

What's the best plastic glass/ isenglass cleaner/polish? I've used meguires and it's ok but wondering if there something better?

Has anyone replaced an ac pump with 4 wires? I ordered a new March pump but noticed it only had three wires. I'm having a hard time finding one with four. Marine Max has an OEM pump but it's almost $500

I'm replacing my ac water pump on my 340 sundancer. I ordered a March pump that's supposed to be a direct replacement for my original cruiseair pma 500. I hooked it up and went to connect the wires, I noticed the new pump has 3 wires (black, white and green) and the old one has 4 (red too). Is...