Hi, anyone know where the DSM250 is installed in a 2005 320DA?
Trying to replace the Electronics kit with a new Raymarine MFD that has built in sounder .
Thanks
Hi, my Smartcraft is showing Engine Operating with reduced Power, IAC Error.
Looking into the Fault it shows Port IAC Error.
However, Both engines Idle just fine. would this be just the sensor failure and not the IAC valve itself?
Thanks.
Hi,
The belt on my Merc 350MPI broke and I'm trying to replace it.
I loosened the 5/8 nut on the Idler adjuster wheel and tried adjusting it using an 8mm box wrench.
The adjuster will not budge.
Any hints on how to unstick this?
Probably badly rusted.
Many thanks
2005 320DA
Merc. 350Mag MPI
Experienced a 0V reading on the Charging Meter, then LOW Battery Warning on the Smartcraft. After running for a few minutes the Engine shutdown.
Voltmeter had been reading 12V for about a week. then earlier that day 10-11V at 2000rpm. Dropped to under 10 at 3000+.
Could a dead, perhaps shorted...
Hi, anyone know where the Espar Deisel Furnace is located in a 320DA Sundancer?
I believe it is in the Starboard Bulwark amid ship.
If so, how does one gain access to service it?
Thanks.
Hi,
What's the best way to remove and reseat the Thru-Hull transducer fitting. It says 'Hand Tighten' but I can't loosen it by hand.
It appears the fitting was incorrectly/sloppily installed at the factory and now leaks.
Boat is way out of warrany so can't go back on Sea Ray at this point.
2005...
Hi, I have water ingress on both Starboard and port sides just aft the forward berth in my 320 Sundancer.
Does anyone know how to remove the front berth bolster so I can dry it?