Search results

Why did you accept the damaged shipment at all, let alone install the engine knowing there was damage? If the failure was caused by detonation, the blame likely falls on the installer for installing an engine with damaged parts, or improper setup such as timing, wrong plugs, valve lash, fuel...

Sorry to hear about your friend passing. Have a safe & enjoyable new year.

:thumbsup::thumbsup::thumbsup:

I saw the youtube video, talk about a fire-breather!! Saying he built the ultimate overstatement would not be an understatement. Too much is never enough... what is he going to build next?

It is hard enough to get the power to the ground in a car, let alone through a single rear tire with very little weight over it. I bet a CBR600 would run circles around it. They make a great conversation piece, will certainly draw attention & must sound awesome. They should come with hour...

Quailrunner had some good tips, check those areas for sure. As far as the drive assembly: There is a rubber gasket which fits into the gimbal housing just behind the ujoint bellows which provides the seal for the bellows, the gasket prevents water from reaching the seal, under ideal...

Diluted bleach was a good suggestion, just be sure to rinse thoroughly after use to prevent the bleach from decomposing the stitching if you spill any which soaks in. Spray Nine by Knights Marine (Spray 9 )? does an excellent job on vinyl, (don't use it on clear though) gelcoat, bilge...

Did you ever resolve your drive issue? I know of a V250M v-drive which may be available here in San Diego.

Sorry to hear of your ongoing issues with your boat. After reading the thread, I decided to chime in & share a story which may be helpful to you or others, & there is a remote possibility it might apply to your current situation. I recently witnessed a strikingly similar vibration/noise...