Search results

Curious why you dont like boat blanket. I just made two fender covers with it to test out. I see you have a colored hull too. Anything I should be concerned about? My old fender covers were a mix of the WM kind that are like a woven material.... which gets picked/snagged and ugly eventually...

Thanks. Will look into those if I have to swap them out. For now, both are working and reading properly. Just concerned about that clip and if it serves a purpose other than advertising who the senders were made by (on the red zip tie)

Hi All, Cross pollenating in case I posted in the wrong forum. Here's a link to my original post over in Sport Crusisers. #1 Thanks James

Hi, So I installed replacement fuel senders from Royce Industries back around 2014-2015 and also got replacement floats when they determined that the float material had ethanol issues and sunk. Only had to replace one of the two I have... Until this weekend that is. Finally the other one...

Absolutely agree on cleaning the panel! That could be an expensive issue if it gets really out of control

@Cocktail Time and @Phil S -- Awww sheet. As mentioned the pump out deck plate is all the way on the stern facing aft. The vacuum tank and storage tank is aft on that side. Believe the vent has to be further back toward the port stern too but will look. Right below this switch compartment on...

Yep we are thinking the same way on seeing what's behind door number 1.

Yes... so I'm wondering if it's getting vaporized in the rising heat from the motors under the floor there and finding its way over to "condense" on stuff. That's the only thing I can figure out. That was my original thought regarding batteries and perhaps battery vapors, corrosive.... but...

Anyone ever seen anything like this? I have a yellow fluid that is leaking out around the battery / breaker switch panel. It seems corrosive as it's rusting the back of the battery compartment latch and also the stainless screws in the compartment in the panel. I've cleaned it up several...

So Marinco bought Guest. Mine is a Model 22040A 5" spotlight. Part Numbers: Bulb - 22014-P Rubber Rim (seal part around the bulb and front bezel) - 22093 Rubber Boot (if needed goes inside around the gimbal and inside the spotlight housing) - 22032. (apparently this is replaceable but not as...

I would recommend checking to see if whatever water heater you end up selecting has a stainless heat exchanger. THAT is the part that always dies. The water tank itself (in my experience) does not rot out. It is the corrosion of the connections for the recirculating heat exchanger that rot...

Hey thanks! That gives me a starting point for the part number / exploration even if its slightly different now.

Does anyone happen to know if the original metal/stainless spotlight on a 2005 300DA is a Guest or Jabsco? I need to get a replacement bulb and didnt think to look as I was leaving the marina Saturday night in the dark. Both bulbs/filaments blew as we were pulling into the pier at dusk. In...

There are two GFI outlets... One in compartment above and to the right of the head... and the other in the mid berth under the stairs on the wall facing the bow.

The old insignia had a 110v plug with a power brick that converted down to the 12v the TV ran on. We cut the brick off and hard wired it directly to the boat's 12v system via new cigarette lighter outlet and 12v male adapter on the end of the TV wire. The newer ones don't seem to have that...

Will be at the boat tomorrow or Sunday and will snap a few for you!

I removed the original 25' chain in my 05 300DA and added 100' of chain. Originally it was 25' chain and 250' of line. I took all the line out of the locker and reversed it so that the most unused portion of the line is now spliced to the anchor chain. I also cut 50' off the well-abused end of...

I added a VESA swing arm mount and installed the insignia 24" smart TV in my 300DA. Insignia™ - 24" Class F20 Series LED Full HD Smart Fire TV

Interesting... I thought it was Length Over Air -- Looking from top down furthest bit forward to furthest bit aft. Ends up the same.

I just replaced my original replacement with an Insignia 24" smart TV. Insignia™ - 24" Class F20 Series LED Full HD Smart Fire TV