Hope I am posting in the right forum. I am in the process of selling my 1992 290 Sundancer. It's the narrow 9 ft beam and it has two 175 hp Mercruiser V6's with Alpha 1 drives. I have only had this boat since July 2007 and I haven't used it much. Several potential buyers have asked me what...
SR and lm - thanks for your comments. I visited both Lake Murray Marina and Lighthouse a week ago and agree with your comments. Right now my boat is in a storage yard getting it ready and I hope to move if by mid December.
Thanks for your comments, guys. Chuck, yes I did see the pics from Keowee. I been up to and around lake Keowee, but not on the lake. I like the scenery up there, but as Marvin points out the season might be a little shorter just due to the location. I know it gets hot around Columbia...
I live in Simpsonville, just east of Greenville SC and am considering both of these lakes. I do not trailer and would rent a slip. Keowee is 1 hr 12 mins away and nearest marina on Murray 1 hr 30 mins away, so distance doesn't rule out either. I have checked with a few marinas and they all...
Would like to know if anyone has done this on same or similar boat. I have done all the checks and am positive the problem is the sending unit itself. The distance from underneath the deck to the top of the gas tank is probably around 3-4 inches, maybe a little more. How much headroom do I...
Tjänare Daim,
If you want I can check with the Sea Ray dealer here in Greenville, SC. I'm pretty certain they will need the hull number to make sure they get the right part. I ship to Norway once in a while and depending on the weight, I'm guessing that part will be $50-$60 in airfreight to...
Yes, I have been in contact with them. With shipping the cost for poles and camper top (roof only) will be very close to a grand. They are currently my plan B and will most likely become plan A once we get closer to the 2008 season. The poles are the most expensive part. If I only could...
My beam is 9 foot 0 inches. From what I have learned so far, my hull was in production until end of 1993, so I'm guessing anything 94 or later won't work.
Thanks for posting, though.
Kåre
Upgrades
Hi Cristos,
Not sure exactly what you want to accomplish, but here are a few suggestions. If you need/want to upgrade the panels that the instruments are mounted to, there are companies that cut these out of laminate at a fairly reasonable cost. You can go with black, wood grain or...
Upgrades
Hi Cristos,
Not sure exactly what you want to accomplish, but here are a few suggestions. If you need/want to upgrade the panels that the instruments are mounted to, there are companies that cut these out of laminate at a fairly reasonable cost. You can go with black, wood grain or...
On my boat, there is a small piece (4-5 inches) of frayed wire attached to the deck just behind the anchor pulpit on the port side. It's hard to say what it's for, perhaps it was used to hold the anchor in place. Does anyone know what this should look like? I'd like to repair it back to...
Hi, I am wondering if anyone has replaced the sanitation hose in a '92 290 Sundancer. I've looked inside the small cabinet in the head and can see the hose disappearing into the aft cabin on the starboard side, but it's unclear to me how much work is involved in getting the old hose out and the...