Search results

Anybody help me with where to locate a sender unit for 100 gallon tank 1996 Sundancer gasoline

Thanks for all the info . Although I've got coverage with the travelers policy I'll never use. Like dingy, hurricane dry storage to name a few . It's still better and cheaper then other quotes i got . Like mentioned above . Take me to the cleaners

Has anybody had their rates jump excessively over last couple years ?? Mines raised over 200$ since 2019. There have been zero claims . I've thought about searching for new insurance, but been with them twelve years . Thanks

So I got an updated set elbows that replace the old style on my 96 7.4 .Mercruiser tech gave me part number . Problem is my boat use 3 inch riser block between elbows and manifold . Plus old was fastened with studs . New one are about 6” bolts . But bolts need to be about 10” to use riser...

Anybody have a cross number for #816900-C?

I installed new riser and Barr manifold 6 years ago . I’m hoping it was flaw in the casting . And a new one corrects problem

So I developed a exhaust pop through carb at 3300-3500rpms. I back off throttle clears up. First thing came to mind was I crapped a flapper valve . May been lodged in exhaust . After tearing into . I have water puddling front of #5 cylinder in exhaust manifold. I changed riser spacer block and...

Anybody have any feedback of flyfish carburetors? Think I’m going to order one

7.4 carb . Coming down on plane high side of rpms get a miss. Idle, no wake speed , low, mid range boats powers up great! 4 barrels opens and fuel spraying nice. New fuel pump and separator . Didn’t help. Going to throw money at full tune up cap rotor etc. Just seems weird high end rpm only miss...

it reads 12v disconnected from alternator.I guess that's reading battery through starter?Ive done some research since post.I have a Mando alternator .So if I try testing across B-B+ should there 12v motor off?Then start and should read more little rpm added? I tried testing from orange lug to...

I seen orange wire on alternator need a new crimp end . Old one had been hot . Just thinking old , I’ve owned boat 11 years . I installed new one . As soon as o fired motor. Orange wire heated up like direct power ????. I killed battery switch. With orange wire disconnected from alternator it’s...

Any way to adjust top side of shift cable without bravo tool ?

I have a 96’ 7.4 bravo 3 drive 270 Sundancer . Need part number for new mechanical fuel pump mounts to water pump housing .Thanks

Check with Michigan Motorz . It been couple years bought I bought B3 drive mercruiser

If you can change oil . You can change out drive . Hardest part is weight of drive.

Cheap about 100$ at boat shop housing and impeller. Have seen 55-75 amazon

Question. How much hard sheathing housing sticks thru boot. My cable doesn’t have a mark as some I’ve read about ..Thanks

Can anybody tell me how thick plate at bell housing is ?? I think 1/4”

needing the 2 rubber washer gaskets for lower acorn bolts alpha early bravo transom bracket. I can find bolts does anybody know if they sell just gaskets ??

Deleted