Search results

she's a 2000 model, I want to upgrade from the vinyl handles - but have to have the same length between mounting studs - 200mm

Anyone have any idea who supplies sea ray with their stainless grab handles - I'm after some 8.5 inch ones for my 210.

After some inspiration or general ideas on how to freshen up the look of my 210 br It's in green with the decals in gold. I'd love to reapint the thing but can't justify the cost. I'm thinking new decals, just not sure what to go for or what colour scheme, the swoosh bit at the back makes...

anybody know who the current oem sea ray use for their steering wheels? looking to upgrade mine on my 210 br.

thanks for the reply, will get down on the boat tomorrow with multi meter and wiring schematic.

I've just bought a sea ray 210 BR year 2000 and I'm fitting a wakeboard tower and some cockpit lights. Could anyone tell me how i can use the eim pad to activate my cockpit lights that i have just fitted? Is it possible to take a feed from the interface module? thanks

Looking into buying a bit of a project 180, it currently has the standard 3 ltr. I'm just wondering if anyone on here knows if a 4.3 unit will fit into it. I know it's never been available as an option but I'm keen to have a go. anyone know if it has been done before?

as posted above, i would personally have installed it roughtly where the carpet bunk is on your trailer. Keeping it away from a chime where there is a smoother less interupted flow of water. If fitting a through hull transducer on 175/176/180 sport i usually drill 24 inches from back of hull...

hummingbird.

NGK plugs for the 3 ltr are bpr6efs

good call - I'm going to need a fairly lengthy distraction! still on the hunt for a section!

just another update - tacomarine no longer make the fendering and sea ray use a a different type. It's looking likely that i may have to replace the fendering around the whole boat - which is a pretty horrible thought.

I've emailed Taco but they don't seem to reply. Cost of the section of rub rail is not an issue.

Anyone have any ideas where i can get a section of rub rail/fendering for a 2007 36 sedan bridge? Sea ray tell me it's is no longer available.

yes, but it will be an engine out job.

I've had monster towers in the past, I'm not buying a 175. just curious - i've seen towers on the pre face lifted 175 but not the current model.

just wondering if anyone has seen the 175 with a tower. I notice in the 2010 brochure it is now listed as an option.

pull the drive and replace the o ring, i've seen this happen a few times before. Might be a good idea to actually pull the shifter wire back through and flush with some maintenace spray.

Anyone know when the 2010 models will be released? anybody heard about any new models?

19 pitch high five is what i use on my 2001 180 BR - I did see a huge improvement in holeshot - compared to a 3 blade ali prop.