Search results

Question about a dual voltage Nova-Kool fridge. Works on the 120VAC side but when switched to 12V ...nothing. Breakers did not trip on 120/12V panel, wondering if there is an in-line fuse as well? Trying to get more info before pulling the unit out. Could it be the 120/12v converter? Just...

Twin 350's with 500 hours on 300 Dancer. Fresh water 2nd owner boat. What's considered average hours for an 03'? And, with 500 hours already logged, what maintenance should have already been performed or needs to be completed? Boat is in good condition, although fridges are filthy along...

Here we go... 2001 5.0, Bravo III. Just summarized and started today. Engine Starts, temps good, oil pressure good, idles smooth. BUT, when engine is brought out of idle, I hear a knocking noise. Sounds like the rear of engine near transom. Somewhat worse when drive is in tow mode (up)...

Finally getting around to wrenching on the 245 BUT, local wildlife has other plans. Three chicks have already hatched...:smt021

Have searched for this topic with no luck so I'm opening the floor to this question. Looking to upgrade soon to the 280 or 310 and there is a left over (08) 280 with a single 496 loaded with all the goodies, however, I wanted to know how does the single perform on this size boat? Power...

I am experiencing a slow leak with one of my tabs right at the attachment point to the transom. How do I remove trim tab to inspect further? I removed the mounting screws and the tab would no budge. Not sure if there is a coupling or if there is a direct line from tab to Bennett motor.

Greetings from The Great Sacandaga Lake in the beautiful Adirondacks of New York! Purchased a 2001 Weekender 245 a couple of years ago. Just completed shore power and upgraded the V-Birth with a 4" memory foam pad (HUUUGE difference). Now we are looking to grow into a 280 by next season...