Search results

Hi Chris I have same problem with my genny. Where did you order the k5 relay and the 120 ohm resistor? Thanks very much!

Oh I forgot to mention that it is a mercury smartcraft

Does anyone know a fix for a non working depthsounder? I have a 2006 40 sundancer. The water temp display does not work as well. Thank you. Rick J

Rich Appreciate the feedback. There are 4 screws on the faceplate that are visible when the tv is up in the ceiling. Have you tried removing those?

Does anyone know how to replace a salon tv that is mounted in the ceiling and drops down for use. I have a 2006 40' sundancer. Thanks for the help! Rick J

No it does not. I tried doing the factory reset but nothing happened.

I have a 96 370 dancer. The rear AC unit will not work. The digital control panel reads 71. Nothing works. I switched the digital panel with the forward unit and nothing changed. So it doesn't appear to be that. Does anyone have any idea??

Thanks guys...I will give it a go this weekend. Leaving on vacation in 3weeks so I want to make sure this is done. sounds pretty easy. Thanks again. rick

I have twin 310hp in my 96 370 Sundancer. Can anyone tell me how to change the tranny fluid and get at the filter screen. The fluid has not been changed in years. Thanks much, Rick

Thanks guys. I will change the battery this weekend. I will also check to ensure the ground is good. Not sure just where to check the continuity. Any idea where to start? Rick

I have a Raychart 600XX on a '96 37' Dancer. It is connected to a RAystar 108 GPS antenna. I cannot get it to pull a signal. Additionally when I have my Raypilot 650 turned on it too becomes inoperable unless I turn the plotter off. Anyone have any suggestions? I am at a loss. I tried to...

Thanks guys for all the feedback. I will change the fluid and filters. Good advice about checking the tranny fluid often. I have added it to my list of b4 you leave the dock checks:) Rick

370 TransmissionNoise Thanks for the response. The fluid is dark red and does not smell burned. I have never changed the fluid or filters. The souund is pretty light but certainly noticeable compared to the other side. Fluid level is right where it should be. Any moe suggestions?

I have a 1996 370 Sundancer with gas 310's. It has gas engines. When I engage the starboard transmission it makes a whine like noise. This is the first year I have experienced this. The boat has 300 hours. The transmissions are Hurths. Anything to concern myself about or is this a normal...