Search results

Good Morning, My name is Patrick and I am currently evaluating a 2011 310 Sundancer. I was wondering if anyone may be able to offer some advice on nailing down a good price for this particular boat. It’s a new boat (2011), and it’s fairly loaded. It has the Axius system, GPS/Chart Plotter...

Patrick 2007 36 Sedan Bridge Red Wing, MN Gas **For Sale

Hi All, Are there any common reasons why the windlass would die? It stopped this afternoon while retrieving the anchor (the last 25 or so feet by hand was fun). The main anchor switch in the bridge was still on and it would not respond using the up/down switch in the bridge or the foot...

Hey Folks, Are there any common reasons for a "UU - Low Voltage" reading on the generator? Fired it up for the first time this year and it shuts down after about 5 seconds..It shuts down with the same error code whether I start from the control panel or if it's a manual start. The only...

Coax Cable to Glomax Hi Folks, Has anyone ever had to actually connect the coax cable coming up out of the Glomax mount to the female connection within the antenna itself? After quite a bit of troubleshooting of seeing all snow in locations where everyone around me receives channels, I...

Thanks for pointing that out.. (321) 449-8628

Hi John-John, Do you know if Sea Ray has applied the latest update for your EPlex clock module? Early this Spring there was a tech that was traveling around visiting a lot of the DB owners with this system and was updating the system. Both Kevin and I received the updates. I had constant...

Hi Kevin, thanks very much for the explanation..This makes much more sense now. Pat

Hello Everyone, I'm looking for information on hooking up cable/Internet at the dock. I'm in an area where I get no over the air tv stations and using an air card for Internet (regardless of carrier) is not an option. Can someone tell me if the coax cable behind the salon TV needs to be...

Thanks very much. KevinMC sent me the same info. Went out and downloaded the manual and found the diagram. Yep, that picture was of the boat when it was delivered..Turned the antenna up right away.

Can anyone tell me the exact height from the waterline to the top of the all around white light on the radar arch? I am looking at a few other marinas for next year and one of them only has a covered slip available.. Thanks, Pat

Hi again everyone, I have what is probably a very simple question and I hope someone could take me to school. I am wondering what the correlation is between actual engine hours on my smart craft display vs. the # of hours that the engines are running. For example, one day last week I had...

Hey Wet Paint, I'm still waiting for a bit more info, but I had Marine Max take a look at it late last week and it sounds like there was a drain hole that was for some reason caulked over. There supposedly is a drain hole directly beneath the locker that is just outside the salon door...

Hey WetPaint, Thanks for the reply. I peeked under the port side sofa to look for anything obvious but did not see anything. The carpet underneath the sofa was also dry. I will give it another look some time this week. Yes, it did rain quite heavily Friday night, but the wetness did not...

Hi Everyone, I'm having an issue that I would like to run by the group. This past weekend I had constant issues with the carpet just inside the sliding door getting soaked. It is literally when you walk through the door. It's a rather large area that gets wet - it extends about a foot or...

Sorry, please disregard my posting. I re-read some documentation that I received from a Sea Ray Tech and it clearly states the waste tank reads 0%, 50%, 100%. Thanks.

Hi Folks, Can anyone tell me if the waste tank level on your control panel registers in increments or is it supposed to show a real time level like the water tank? My observation from this long weekend was that it was reading 0% on Friday. Saturday it finally registered a reading but it...

Also, here is another picture to give you more ideas. This was compliments of another gentleman here on CSR. This is what I am doing. There will be a separate piece secured with Velcro that will cover the hatch when desired.

Hi Kevin, I am currently in the process of getting a sun pad made for the Wife and we are at the same time having a custom cover made for the aft part of the bridge - something that we can decommission/recommission rather quickly and enjoy more open space. I'm working with a canvas guy in...

Hi Folks, Does anyone have any input on removing the metal frame from the aft part of the bridge? This would be the frame that is supporting the canvas. I'm not sure if this is something standard or not, but I'm wondering if anyone out there that may have this frame if you've ever taken it...