Re: 410 Sundancer/Express Cruiser and 400 Sundancer/Express Cruiser **Official Thread
Rick -
I installed a Water Witch in my mid-cabin sump last year. We have been very happy with it and like the extra run time as well.
Another tweak I made was to rotate the sump compartment such that the...
I just went through mine. I found that West Marine carried the exact Attwood switch Sea Ray had in it. This got me by until I decided to 'overhaul' the installation.
To eliminate the 'short cycling' of the float switch and allow a more complete pump-out, I went to the Water Witch switch...
Glenn - I had a 1993 330 and now a 2007 40 Sundancer. In both cases, I installed an Isotherm tank. They are well built stainless steel units and have a mixer to assure safe output temperatures. Recall, engine heat is up to the 160+ degree range and 120 is a recommended hot water temp. Sea...
A friend of mine who is... well... exceptionally detailed in research (i.e. anal) and getting value for his $, purchased a version of this system. He mentioned he went along the lines of the no monthly fees for monitoring. This is done by using a cell device pre-loaded with minutes and...
Kellertb -
I had this 'click' issue on my new 2007 40 Dancer. By pure accident, I tugged on the wires at the connector within the actuator shroud and one became disconnected. Bottom line was a bad crimp on the connector, thus limited amperage to the motor. I replaced the connector and all...