Search results

I have a 99 340 dancer now , I changed the profile but it didnt take. The engine hatch seems weak when you walk on it it flexes and moves. The table wobbles and very flimsy due to the weak deck. When you open the engine hatch the water drips out of the frp core. I want to replace or repair...

Mine is shot very flimsy hold water in the glass. Anyone have an idea to fix it ?:huh:

Mine just detonated hole in casing. Must replace drivers side starboard engine . :smt100

The columbas day regatta one of the best boat partys in the country !! dam this sucks.

Will it fit an 1999 340 dancer ?:huh:

can't find the shower sump box whre is it ?

Ruled out the ac because , I took a short ride 4-5 miles with no air on, started with a dry compartment came back and checked about a gallon had leaked in . Dry day no rain.

Wait a minute the bathroom is in the center of the boat no port hole ?

I keep getting brown water in the center floor storage comp. on my 310 dancer 1998. Ruled out a/c seems to happen while running. Storage comp. seems to have no openings yet fills with water slowly. Cant find shower sump pump where is it ? Water is brown slight head odor but I have vacu flush...

Do you have a gen set running a/c unit.

Vdrives no room i/os much better.

I keep her high and dry on a rack now but last month in the water with air on all day florida is humid .

Dont forget bilge pump alarms

Check the compression on all cylinders could be a bad valve .

looking for best place to purchase new risers and manifolds.

Have a 1998 310 dancer twin v drives 350 mags gas. Use in salt water south fl last 5 years. Risers need to be replaced. Checked compression on starboard engine have 40-60lbs on one cylinder rest are fine. Wheres the best place to buy risers and manifolds , and what should it cost labor wise...

Ok I have a 1998 310 dancer with 350 mag v drives and a westerbake gen set/. Twice now I had a sour odor on cabin opened up the center floor storage area to find 10-12 gallons of brown water !!! After cleaning inspecting this area it has no openings period. No hoses , no holes, no shower sump...

No big deal , leaving it there for a few months water would evap salt will eat parts.

10-12 galls per hour at cruise of 3500 rpms. per engine !!

What speed should I be cruising at with twin 350 mpi v drives at 3200 rpms ? I ask becase I think I have one weak motor maybe skipping , I get around 22 mph at 3200.