Search results

I have a 2003 340 DA. I am getting the following warning sensor "STEER CKT HI PORT" there are no other warning sensors and the starboard ending shows no warnings either. The manual sucks and does not explain and many others so we are left to seek help!! So now I'm seeking help. Does anyone...

Went out Sunday to commission my 340 DA for the season and found out that I had no power to anything: stereo, engine hatch, guages, etc. I had shore power hooked up and both meters showed power to the boat. I turned the solenoid switches on and got power to the boat. However, after a cruise...

My 2003 340 DA obviously has dual engines. The left tachometer usually always read 1100 RPM's. The Smart Craft monitor displays the correct tach. Do I need to replace the dash tach. My starboard engine burns fuel at a higher rate than my port side to the tune of using 12 more gallons...

I realize this is a stupid question but I am NOT mechanically inclined AT ALL! I'm also 6' 4" tall and engine compartments are not built for me....more cuts and scrapes then completed tasks usually! I have a 2003 340 DA. I have no idea where the strainer is or how to do it. Marina owner...

I have a 340 Dancer and use a 16lb Delta plow and have never had problems. My lake is a mud bottom fresh water lake that gets VERY windy at times as I live in Kansas and you know the whole Wizard of Oz thing! Anyway, all I have ever had is the plows and have never had problems. Make sure...

I bought a 2003 340 DA in Sept of last yea and LOVE IT!! Awesome boat and the layout is very user friendly. Upgrades we did were mounting a 26" flat screen HD LCD TV on the wall adjacent to the steps into the cabin. Also upgraded the sound system and added a sub woofer under one of the...

Heading out in just a few so I will check and post what I found out. May be just me being a dumb@$#. Wouldn't be the first time (see Prop Damage) Have a great safe weekend!!

I went to Auto Zone and they were no help. O'Reilly had the replacement rubber and installed it on my blade as I took the entire blade in. I did not take the arm, just the blade. It was kind of a pain in the a@# for the guy but he got it done...no charge for the install. Sorry I can't...

My compass light is either burned out or is not working. I have tried the accessory switches on/off while pushing the compass light button at the helm with no response. I am therefore assuming the light is burned out. Any thoughts on how to test/change it? Thanks

HOLY BAT@#*&!! I left the house and forgot to check the replies to my initial ? Sitting here Monday morning....I guess by luck b/c we ran the gen all night on Friday and Saturday night in the slip with only the SR CO2 detector for safety. We did have a South wind and my slip faces South so...

We were recently struck by a micro burst at our marina. Our finger was torn off it's moorings and snapped the power pole and broke the water connection to all 35 slips. Good news is our boat was out for bottom painting and service work....prop damage! We splashed yesterday and are headed...

I am trying to find a strut or spring type system that will hold the doors of the small cabinets on either side of the forward berth. I have a 2003 340 SD They open from the bottom and the hinge is at the top. They are not large doors and it is a pain when trying to dig out clothes, etc...

I bought new set from Snap-In directly and chose to go with the black backing again. Why- the sample piece of carpet they sent me that had the white type vinyl/rubber backing was not as thick and plush as the one with the black backing. They told me that the ounce weight of the carpet...

I chose to use Sea Hawk Biocide bottom paint. I know the guy who reps the paint and he sent me 4 gallons for free. Don't know much about it but he said it was almost $300 a gallon, so the price is right. Anybody know about this paint??

Keep in mind that I am in a 2003 340 so it may differ a bit. Usually the amps are not far from the head unit. Do some searching and remove some panels and you should have no trouble finding it. Let me know if you can't and I will get the electronic diagrams for you to locate it. Good luck!

I just completed a whole audio/video upgrade and added an amp. If you are looking for the factory amps they are behind the head unit in the control panel closet. You have to unscrew the panel and take the whole thing off. The amps are mounted to the stringer on the starboard side. Kind of a...

Thanks to all who responded. I have one small problem...I live in Kansas, plenty of corn, beef and wheat but GOOD prop shops are hard to come by. Any recommendations on where to send the twins to get worked on?? Thanks!

Ran aground going into another marina yesterday. Just barely hit the rocks b/c the water is up 10 feet and the breakwater jetty is underwater. They marked it with a pole stuck in the rocks with float noodles taped to it. Calling the Corps this morning to complain about inadequate marking of...

Does anyone know where to get new snap-in carpet runners for the cabin? I called the company Snap-In Carpets and they do not make them for Sea Ray only the carpet. Any help would be appreciated. @*#+ing guests spilled queso on the runner last weekend and washing it did not get it out...

Does anyone know where to order cabin door keys?? I have the # from the door that is associated with the key. I am assuming Sea Ray (Marine Max) etc. would be the best place to start but wanted to save time if someone already knew. Thanks