Search results

  1. rmlsll

    Sea Ray 340 Dash Module Switch Starboard Side 1810626

    Sorry, I sold the boat and all the parts that went with it. Here is the wiring diagrams
  2. rmlsll

    Official 2003.5-2008 340 Sundancer Thread

    742xs with a mercury gateway so I get the engine info
  3. rmlsll

    Please help. Switch Pads at helm intermittent power.

    I also had a bad stbd side switch pad. Pulled all EIM stuff out and replaced with fuses. toggle and rocker switches.
  4. rmlsll

    Sea Ray 340 Dash Module Switch Starboard Side 1810626

    I reused the old start / stop/ emergency switches They are not a part of the EIM system
  5. rmlsll

    Sea Ray 340 Dash Module Switch Starboard Side 1810626

    This is what I did. I have a schematic and bill of material if you want them.
  6. rmlsll

    Grand Haven or somewhere else?

    Grand Haven is a good choice. Either the municipal or tie on the wall. I would recommend stopping in Saugatuck just to check it out if you have never been.
  7. rmlsll

    Replaced EIMS with hard wiring, port engine won’t start

    If you have spark, fuel, timing and compression it should run. At least that use to be the case.
  8. rmlsll

    Options for Interior Flooring and Install

    Craig, Just noticed what nice pictures you have. What did you use to attach your pictures to the walls ?
  9. rmlsll

    Official 2003.5-2008 340 Sundancer Thread

    drop headliner down
  10. rmlsll

    Official 2003.5-2008 340 Sundancer Thread

    Yes, by razor blade / box cutter, what ever cleans works. I did not remove the glass...
  11. rmlsll

    Official 2003.5-2008 340 Sundancer Thread

    Yup, I recaulked mine a while back. Dug out the old caulk, cleaned them up and recaulked with life caulk. Watch those deck rails / grab handles. They will leak and its a bitch to get to the bottom of them.
  12. rmlsll

    Sea Ray 340 Dash Module Switch Starboard Side 1810626

    Sorry......I've got a good port switch pad (starboard is broke) and both EIM boxes.
  13. rmlsll

    Westerbeke 8.0 BTDA kicking my arse

    I've been using manual_service_35e_44c_8-15 btdc_45100_rev_2.pdf (westerbeke.com) pages 71, 71a, and 72 The first trip to the boat had no idea what was going on (no schematic , just a fact finding mission) Did notice no 12v to remote stop switch. Pulled wire off remote stop switch but gen kept...
  14. rmlsll

    Westerbeke 8.0 BTDA kicking my arse

    Fuse is for sure good. The stop switch on the generator panel works fine, but the one on the remote panel does not work at all.
  15. rmlsll

    Westerbeke 8.0 BTDA kicking my arse

    So..... I've got one for you Westerbeke guys. I'm helping a friend with a "2001" 11.0BTD Westerbeke diesel generator. Starts and runs fine from either generator control panel or remote control panel. Problem is it wont stop / turn off from the remote panel. Tried opening circuit at remote...
  16. rmlsll

    Sundancer 340 2004 impeller replacement mercruiser 8.2 MAG 496

    V-drive ? Get the mufflers out of the way. Will make the job a lot easier.
  17. rmlsll

    Looking for 2003-2007 320/340

    Dave, I have a clean low hr. 2004 340 that I'm starting to think about selling. It's in Saugatuck MI.
  18. rmlsll

    Official 2003.5-2008 340 Sundancer Thread

    I had it where the shower / AC sump pump was bad and the pump box over flowed
Back
Top