Search results

NIB. I purchased these stainless fender baskets for a SeaRay that I no longer own. These fender size is on the basket label with a check mark. Buyer to pay shipping and handling to their address. I cannot get a picture posted here anymore for some reason, so here is a link to a local...

I have a new wiper arm I purchased for a Sundancer I no longer own. I can send pictures if you are interested. PM or email at thompsdw@hotmail.com.

I purchased these for a Sundancer that I used to own, but no longer have the boat. They are NIB with the rail mounts. I have more pictures I can share if you are interested. PM or thompsdw@hotmail.com. $75 + shipping.

I have the boat listed in the title. I wanted a wiper on the boat, because when I purchased the boat it did not have one installed. I purchased a wiper arm but the splines were way to large for the motor that was on my boat. The motor on my boat has a 1/4" splined mount. I think that the...

I need to replace about 10' of rubrail base on my 2000 270 Sundancer. Not having much luck with the search function here or on the net. Any suggestions? DWT

My boat is located on a river in a dry stack. It is amazing the dirt and bugs that get into the boat in my location. The cockpit cover just doesn't get the job done and the tarp is just too hard to manage. Has anyone found a reasonable "over the rub rail" cover. My boat does not have an...

I don't have shore power, so I have a little different setup. I am using solar chargers to charge 2 house batteries listed in the title. They routinely float at 14 volts. Is that a problem, or not? I'm a little worried that they are overcharged. Any help in appreciated.

This didn't fit in the other thread and I didn't find anything after doing a search. This polar plunge is coming in a little earlier than my winterization appointment. Our forecast is 27 F now, but it seems to get colder by the minute. Is there any safe temporary (light over 1 night) way to...

And I am wondering what checks I should complete before taking it out this weekend? Any tips?

I was previously in brackish water with high salinity. I installed two mercathodes in series to fight the corrosion on my Bravo 3. I am dry stacked now in my new location. Will leaving them connected hurt anything? Disconnect them?

I recently replaced the u-joints on my Bravo-3 drive due to a knocking sound with hard port/starboard turns. Was quiet for a short time and then the knock came back. Arrrrggghh. Job went smooth with no problems. Put in a new gimble and belows at the same time. Anyone ever had this problem...

I want to upgrade my TV to a little bit larger size. I found a Vizio that only consumes 23.8 Watts. But for this model I would have to invert versus have a TV that runs on 12V like my current NAXA. So here is my question, if I do go this route - is the power consumption of this setup...

What is the best injectable (I can't get to the back side) sealant or adhesive that is drillable and will hold a screw for stripped out screw holes? I was actually thinking about construction adhesive, but not sure how "solid" it becomes when cured. Moisture resistance is not a big issue in...

Hi guys. Curious if anyone has any experience with these batteries. Deka makes these batteries. While I am a fan of the Sears Platinum AGMs, these are $100 cheaper per battery and I need 4 of these for my boat. Deka has a pretty good name in the PWC world, but not sure on full size marine...

I am being relocated from Houston to Richmond VA. I already found a home for the boat at the new location, but now I need to find someone to transport. I used UShip to get an idea on rates, but what I am finding is that I am getting a lot of flatbed trucking companies that want to block the...

I have been searching posts to see if I can get an answer for my situation, but cannot seem to do so. So, we do NOT boat far off shore. We always are within cellular range for the type of boating we do. I have a new Garmin 740s chartplotter that I use to navigate. So, I am asking the question...

I have a lightly used, excellent condition Garmin 540s for sale with power cord, transom mount dual frequency transducer, and GPS. The transducer bracket (not the transducer) is plastic and has a small crack, but otherwise the unit is in excellent condition. There is some sealant on the...

Brand New in box U-Joint by sierra marine part number 18-1711 replaces mercruiser 862132T. Fits mercruiser bravo drives (some not all) and racing drives. These are the really heavy duty u-joints (and expensive). $150 shipped to North America.

I did a search here and found some threads, but none where anyone had found the seal material. I'm getting a lot of noise from the hatch and I have looked at home depot and Lowes for some type of weather seal, but cannot find one that fits the original seal material for the boat. They are...

I'm thinking about upgrading my Garmin 540s to the 740s. Big driver for me is the larger screen and the touch screen. Its just a LOTTA dollars for the upgrade. Any other thoughts? Is it worth it?