Search results

Hi everyone. I am in the process of researching what Davits to install on my swim platform. Does anyone know the depth of the platform? The overall length of the boat is 39'. I'm assuming the platform would be 3 '? Ant insight would be appreciated. Otherwise it will have to wait until the...

I have always done mine. I usually dedicate about 1.5 hours per side. It was very helpful to remove the port exhaust tube when changing the port impeller.

Re: Zinc's? Ctsearay, Our 2004 360 did not have any anodes on the rudders. I have them on the trim tabs and one on the bonding lug located on the transom.

Great explanation. Thank you.

I had a 2004 300 DA and would cruise at 3400 rpm and consume between 22 and 24 GPH.

Has anyone tried mounting a flag to the stainless steel bar that is directly behind the rear bench seat (above the transom locker)? I have tried two different mounting systems and have been disappointed each time. It appears that the bar is not completly round and therefore does not allow for...

Jeff, Next time I'm up at the boat I will snap a few photos.

Thanks for the reply. I removed the sound cover today and changed the spark plugs. The genny started right up and ran fine under full load. I think I'll order an extra set to keep on board.

Thanks Bryan. That would be great!

Hope everyone is getting ready to launch and start enjoying time on the water again. I did just that today and had a few problems with my Kohler Generator. It would start but very quickly began backfiring and sputtered out. The fuel filter and plugs are new. Has anyone had any thing like...

I have owned various boats over the last 25 years and have NEVER fogged an engine. The marina I currently dock at also does not fogg any of the 400+\- boats they haul each season. With over 400 hrs on my last boat we have had no adverse consequences.

Jerpro, I upgraded from an RL70CRC to an E-80. I did have to cut the existing "wood" plate to make the hole larger. I also had to pucrhace a split pedestal cable from RM. The pedestal is not powered through the display like the RL unit. I have pics posted in this thread of the final...

Great job explaining a very difficult project. Very nice photos!

Thanks for the reply Billfletcher. I only have 169 hrs so i hope to get at least another season out of mine. I have also attached some photos of my recent upgrades including installation of a new 19" flat screen TV and a new E-80 on the dash.

Billfletcher, were your shaft seals leaking? I was curious as to how many hours I can expect to get out of the dripless packing/seals.

Billfletcher I installed a 19" Samsung that fits like a glove. I will post pics this weekend. Concerning the wood steps, I did check with fpmarine, but they are currently out of stock! If anyone else has any idea where these wood steps can be found I would greatly appreciate any suggstions.

Getting ready for the boating season in Catawba Island, Ohio. We have already completed some major upgrades this winter including installing a new E-80 display and scanner, new flat screen TV in the master, and new cockpit carpet. I have one more item on my list and that is to install wood...

Hello fellow 360 owners. Has anyone replaced their aging RL70C unit with a newer C-Series unit. What was involved and what was the approximate cost. I understand that the array will need to be replaced, but what else is involved. Thanks in advance for your assistance.

Hello all. I just joined the ranks as a new 360 Sundancer owner. Hoping to take delivery this week. Can't wait to get my hands on her.