The Starke Ceramic held up so well last year, this winter I gave her a hand wash with a mixture of Starke Venom to remove all of the contaminants and water spots, then applied a spray on coat of their Replenish. Pretty happy to not have to buff anything this winter.
Splashed on 4/8, all good except for the freshwater pump this year. Decided to upgrade to a slightly higher flow rate, accumulator, and the kit to quiet the pumps down. What a difference!
Late to the game here but I love my 20 HP white Suzuki. It has been bulletproof so far. I was looking for the lightest weight 4 stroke 15-20 HP I could find because of my lift system and how it sits so far back, didn't hurt that it was painted white either! Whoever thought black engines belonged...
The ceramic held up very well from last season, this winter I just need to wipe down the topsides with the water spot remover from Starke and wipe her down with some Replenish to boost the coating. Very thankful for that!
Yes it is, we do the same. It was about $25 last month but the door was opening and closing a ton bringing things in and out. The entire garage is spray foamed and pretty tight.
I’m guessing this month will be a little more with the super cold temps we have been having.
This is the one I...
Very easy. You can pressure wash right through it or hose it out. If you really want to, you can slide a section out once a year and clean it normally.
I didn’t want to mess with puddles or piles of dirt. Everything goes right through and you always have a dry clean floor to walk on.
You...
I have been having the same issue with a slight surge at idle once the engine is warm. I did not have a great experience with one CAT tech, but then had a great experience with another from a different location.
We did "check" the check valves but I was never convinced that the first guy knew...
Three Lumitec SeaBlaze X2’s going on my boats transom this winter. After drilling a bunch of holes for the tunnel tabs, I got over it.
Drill away and enjoy your lights. If you’re really worried about it, check them when you pull the boat for a bottom job each time and re-seal them.
If...
Took a look over the weekend. It is indeed just a piece of wood behind the hinge which has rotted enough to the point that only one screw will take a bite.
I haven't decided exactly how I am going to tackle it but here are my thoughts.
I am going back and forth on either drilling a few...
400 Sundancer Swim ladder cover:
Has anyone successfully filled the cavity behind where the swim ladder cover hinge connects to the platform? Pretty much all but one of my screws are loose now and I need to do something to properly fix it. I haven't fully taken it apart yet but I suspect the...