Search results

Thank you Bennett!

On my 2007 44 DB, the right channel speakers on the stereo are not working inside the boat (cabin) both in the salon and forward master stateroom. Cockpit and bridge speakers, left and right are working fine. The problem is not with the original Clarion stereo (right side RCA jack output is...

Thank you.

The shift controls are electric, not mechanical. There is a forward and reverse shift solenoid and coil on each engine that actuates a valve that does the shifting. As it turns out the connector to the solenoid was going bad. As it heated up from resistance, it would not shift the port motor...

Makes sense but I don't think you can change units of measure, especially different units on the same Smartcraft page but I'll check. I'll try to post a pic of the readings...

Yes, no issues. Was just scrolling through the system and noticed this.

Turbo Boost Pressure Reading 0.0 Noticed my port engine Turbo Boost Pressure reads zero PSI on my Smartcraft, while the starboard engine shows 14.2 PSI. This was with a cold engine at idle. Anyone know why it's reading 0 or why a cold engine turbo would read 14.2? Which side is the problem...

If you are having issues with your ZF Transmission in the NJ area call AUTHORITY MARINE 732-291-0012 and talk to Rob or Scott. It started as an intermittent problem and I luckily avoided a really bad situation when I lost forward on my 44 Sea Ray Sedan Bridge while trying to dock my boat in my...

Neither green or red light on my HALON Sea-Fire dash switch is lit (charged/overcharged indicator). I found out the hard way when I was dropped in the water and the Cummins QSC 500's would turn but not fire on my 2007 44 Sedan Bridge. After a couple of phone calls I got help and switched the...

Hey Ron, thanks for the info. Yes, I've seen him around at LPM and was one that I was considering calling. Although they are "building" a service department with the new GM recently hired at the marina, no one has a bearing press and they don't want to buy one, so I'm on my own to find a...

Anyone know a good mobile mechanic who can replace cutless bearings? Prefer they have a bearing press, I don't want the shaft removed. Boat is located in Toms River, NJ. Thanks...

Anyone know a good mobile mechanic who can replace cutless bearings? Prefer they have a bearing press, I don't want the shaft removed. Boat is located in Toms River, NJ. Thanks...

I just moved up to the 44 and need to replace the all around light on top of the radar arch. This may sound stupid, but I can not figure out a safe way to get to that light to change the bulb without possibly breaking my neck. Do you have to unlace the canvas top? I do not have the 1/2...

Thanks Fred I appreciate it. Just spoke to the surveyor and will be meeting him Saturday morning at the marina. I did not see your PM...

I have contacted Sea Ray directly with numerous other questions and have asked the questions you just suggested. My insurance will need to cover this and under the circumstances, price can not be an issue, I need a new door. Thanks, good advice Frank.

Thanks!

Thanks for that tip. The fiberglass was not damaged at all, just the aluminum master frame and aluminum frame around the glass panels. Yes, S. Toms River is a problem for security, evidently.

I got a call from my marina on Saturday that my 2001 Sedan Bridge was broken into while in dry storage in South Toms River, NJ. The sliding door is so badly damaged from the crow bar used that it should be replaced. Marine Max tells me the door originally made by Taylor Made for Sea Ray is...