Separate names with a comma.
Used coffee pot carafe for the LG LCRM1240 found in many sundancers around 2008 http://ebay.us/irfOyn?cmpnId=5338273189
Anyone know of a replacement for the glass turntable in the LG microwave coffee maker combo?
I looked at the switch and it was not in neutral. Didn’t try forcing the arm. I was worried I didn’t get the shift cable in right so chose to...
Thanks guys. Maybe if I mask the area off I can scrub off the area with a toothbrush
I guess I pulled the drive out too far before releasing the shift cable and pulled the cable causing shift actuator to move to reverse. Took drive...
What would cause vessel view to give me a shift alarm after reinstalling my bravo 3? The display thinks it’s in reverse. I’m pretty sure the...
I know you’re supposed to leave a small gap between bottom paint and drives. How important is that if the drives have zincs and mercathode? I’m...
Where can you find the type of resin used? I’d like to know what my 08 310da has.
In case anyone is interested. I called Merc today and they said the pressure test info was in the technicians guide, not the service manual....
Been looking at pullers and they're all over the map price and style. Can you recommend one?
Reading my new service manual about 1.5” thick! Says the gimbal bearing and carrier are a matched set and must be replaced as an assembly and the...
I've researched the job and watched a few videos. I will definitely be doing the job. Already have the drive off. Few things don't make sense,...
Did you look at the links in my post #12? Clearly 2 different items. Unless the merc pic is just an old pic.
Top panels are velcro. Bottoms have push pins. But the pins have a flange on the inside (backside). See pics
Thanks. That looks like a match.
Anyone know where to get the heavy duty velcro and the nylon inserts that are used to attach the side panels? Items 13-16 in attached pic.
So which kit is the best to get, the quicksilver or merc? See my post #12 above. Also, is there any way to replace the U joint bellows without...
Does anyone know where the testing info is located? I have looked through manual #28 and can't seem to find it.
just thought it was funny they have a special tool for everything but in this case you’re supposed to weld a nut to a pliers, then cut nut in...
Look at the Mercury kit vs quicksilver...
