Separate names with a comma.
We bought a 3" Serta Cool gel memory foam mattress (I think it was from Kohl's) and cut it to fit. We got the comforter and pillow cases off Etsy.
I mounted the holder directly to the panel. I did use nylon spacers at the bottom to tilt it upwards slightly for the angle I wanted
Ours wouldnt flow water through the unit last week either. I checked the seacock and water entered through but I never heard the pump come on. It...
There should also be a 15A mini-blade fuse near the back top of the engine behind the distributor a few inches away from the large black plug that...
Thanks for the link.
Sorry, I forgot to follow up on this. It turned out to be a ground wire mounted to a wrong post on the back of the sync gauge. It was blowing the...
I just experienced the same thing with our 270 (twin 4.3 carbed). We were cruisng at 31 knots when thr port engine shut down and wouldn't restart....
Just to update. I did get everything figured out Saturday. There are 15A fuses behind the carbs just past where the big black ignition wires...
Well it’s not plug 1, 36 or 37. Still chasing gremlins
Thanks for the replies. It really helps. scoflaw is correct, the issue wouldn't be at the neutral safety switch as that feed is after the ignition...
Ok, I checked and I have power to the 90A fuse on the starter and power to the 59A breaker on the engine. I also have power on both sides of the...
In need of a little help here. We have a 98 270 Sundancer wide body with twin 4.3’s. I haven’t started the engines in about 6 weeks. No issues at...
Yes the 4.3's are carbureted. The generator would be in the center forward space of the engine bay. Looking at our genny, I believe that it can...
I had an issue when the solenoid went bad on our trailer. Now I keep a block, made of 2-2x4s screwed together, in my tool box along with a couple...
I finished updating/upgrading our helm/dash area with new: -steering wheel -gauge panel -blue bulbs for gauge backlights -center dash panel -VHF...
Welcome, and very nice looking boat.
Here is the template. I almost forgot about posting it.
I have the template drawn out at home. I'll upload as soon as I get a change
It does come in handy. It's made from PVC panel purchased at Home Depot. I did add the cup holders to the table. I also added nylon spacers so...
