Separate names with a comma.
There was a thread recently about the Halon fire systems. Halon is no longer being produced but apparently there are fire extinguisher service...
yeah like the ultrasonic pest control devices. They work for a few weeks until the varmints get used the new reality then they just adapt to the...
I've used all three, I have yet to use the Salt Weapon for the hull yet but will once we get back to home port. Ill be installing a freshwater...
I ordered a Sea Flo 12 GPM 12 volt with run dry protection that claims to lift 4 feet. I ordered from Camping world for $89 I was going to pick...
Good little snaky
Has anyone ever installed and used any of the ultrasonic anti fouling systems on their hulls? I ran across the Sonihull system at the PYI site and...
The aft shower sump is located in the center of the aft bilge under the master pedestal bed with access limited to a hatch that is offset aft...
The deck plates are mounted about 18 inches apart so I could easily install a proper deck hatch. The only reason the plates are there is for...
Yes the conduit in the ER is interesting in that it is not the split tube plastic. it is a box style with barbed fingers for vertical sides with a...
I need to clarify, The engine room did not flood entirely most of the water was confined to the center bilge wells. Only the aft most part of the...
I welcome the question. It is possible but given the entirety of the situation and having access to the boat as I have, I am going in eyes wide...
I just got a quote from my Marine insurance broker going from an 06 44 Searay to a 2000 51 foot Carver. Agreed value at $270,000 all risk came in...
After our recent high seawater inundation on the Carver 506 sea trial I rinsed out the bilge and affected components with fresh water and was...
The boat is in Benicia two hour cruise to SF and Three hours from Willow Berm which really is about the only place we like to go in the Delta.
I drive 30 minutes, used to be 20 minutes to a closer marina but that one was a two hour run to the main river to the Delta or Bay. 10 more...
Slight change of plans, I am going to build a bonding system, Install one aluminum anode on each shaft and have the diver take it off at the first...
The unit is just stuck on the screen posted. I think we tried the protocol to enter the set up mode and cant get there.
[ATTACH] Anyone ever had this screen appear on their SimRad radio? I have scoured the manual as has a buddy that is a radio tech for the State OES...
Thanks Guys, We have decide on replacing bellows since it is on the hard now. I offered to do it myself but the seller insists on paying for it...
This one was posted over on Yacht Forum in a post about shaft seal longevity. I hope to have my ER looking like this one soon! [IMG]
