Separate names with a comma.
The best feeling - only the golfers will understand
Looks like it had a short cable. What extension cable did you use and is there an additional power cable.
Not my boat - you'll have to ask the OP
New boot stripe as well? The starboard side stripe looked a bit 'rough'
I assume you mean 8* C not 8*F? What is the difference in the humidity level between inside and outside?
Don't worry the white stuff coming to Northern Ohio today will cover up the leaves.
Looks good - which camera did you buy?
In order for it to leak through the screws holes you had to have a wet bilge. Correct?
pictures would be helpful.
I've used Greg Group out of Mentor, Ohio (note he does travel), our location is distance wise the same as going to Pittsburgh. He is what I'd...
Why not drill some holes now. Sailors do this when their rudders are (foam on a metal grid) soaked. They drill the holes and let the water weep...
Acetone is a pretty toxic chemical. When working with it I'd be concerned about the fumes and definitely be using rubber gloves. .
You got to it faster than I did. https://www.glcclub.com/
We use to belong when we were crusing and it was worthwhile especially when we would...
An alternative might be a cruising club or an organization like the Power Squadron. Not sure about Florida, but here we have the "Great Lakes...
Why not give Raymarine a quick call to find out if there's a replaceable battery. I've found them very responsive in the past.
Isn't the 125 old tech and using a direct connect to the chartplotter vs. N2K? I had one on a new boat that was commissioned in 2005.
I've had both installed close together on several boats - never noticed any issues.
That has to be a high capacity fuse.
Do the engines have to be NEMA 2000 compatible? I ran into this with a 2005 Yamaha outboard which was not NMEA 2000 compatible.
Did you connect the camera directly to the chartplotter or through a gateway?