Separate names with a comma.
It's round, about 2" in dia. on the starboard side very close to the block drain. Just behind the motor mount.
You assembly is in better condition than the $850 one, I don't see any corrosion. I'd have it removed , repaired and resealed, but not by him.
"relief holes"? that's just plain incompetence. I'd threaten his ass. Your assembly looked fine for a simple repair before this Bozo got his mitts...
No doubt your assembly can be repaired. How much worst does it look than the pic you posted ? The new plastic tube works well if there is little...
Fresh water then, could be worst. I'd flush that baby out a couple of times before I let it sit. If you've been using it regularly I'll bet you...
Merc customer support can tell you that info with that number if the drive is original to the boat
The 1060 is the taller version
It's a GM engine, Wix 1060 is a good choice.
No not that stuff except the wrap shield. Get 3/8" high pressure fuel hose. No stainless, just black rubber so it clamps better and get the high...
I think you got the explanation wrong, that's not how it works. But, whatever other info you have, post it
which diz. what problem ?
That is going to be a real bitch to get that line off. that adapter has a narrow hex molded into it that you will need to get a wrench on while...
They shouldn't be junk at 3 years old.
What the gauge reads means nothing, it's what the ecm sees. You now know it isn't the lube bottle.
Like the OP stated in post 1, even if your sales tax has been satisfied, some states will charge a "usage tax" if you stay long enough. Florida...
So your DVM reads steady while the gauges bounce? Mando is a type of alternator and Merc usually lists 2 kinds per application, 1 being the Mando.
All 3 of those sensors work on a ground trigger. Try disconnecting them and testing them 1 at a time.
The more info you give the better. Answer some of LD's questions in post 3, and anything else that might help.
Grind down a 3/8" extension until it fits.
1/2" extension on a breaker bar should fit it.