Separate names with a comma.
which lights did you use?
Pretty easy. Took about 1/2 day even with some on the spot fabrication that I had to do. Marine Aire is what we used. Really like system....
San Diego Boat Movers moved ours from AZ to San Diego. We were able to piggy back with a load and saved us $$$. If they have one they are going...
I have them on mine. Purchased on Amazon. Bought the ones for motorcycle as they are waterproof.
Maybe 4200? The silicone the gaps?
I Sea Ray tech that worked on building these boats told me it was a common issue and sometimes they put screws in them so it would not happen...
I have to do mine too. I did find this photos for what it looks like underneath.
I took mine out by hand. No bit was needed.
You should be able to buy the bolt (star shaped head). Did that on mine. Not cheap! I think like 80.00.
Had a friend who had his on the market for 9 months. Nice boat! Finally sold for 235000. 2006 44
http://marinepropellers.com/ I got mine here a few years ago and were very good and priced right, : )
Currently in San Diego and planning a trip to Ensenada. Heard very positive things from friends!
Yes, I will later tonight.
I have the factory Berber. I did have to recoat the back is a couple areas but it is in good shape.
I "snapped " in the infinity over the factory carpet it and worked out pretty well without much labor and cost. Quint did a great job! I know...
Interested in both!
They are sealed units from the factory. Only way to replace them is the entire unit. You can also install under water lights in transom.
Just a little fab work needed to be done on the plenum (ducting out of the unit). Used tin snips and some alum tape. Use the thermostat that came...