Separate names with a comma.
The only TV I tacked is in the master stateroom and I'm not happy with the way that came out. I ordered a small mount and extended the TV so it...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] Splashed!
Great idea. I am going to give this a try on a piece in the master head. Thanks! Mike
Block is our favorite destination. Highly recommend more than a day. Travel to and from should be easy for you but just look out for fog and then...
I would also recommend the mooring ball at Sag. Well protected, taxi, and pump out.
I also switched to Carter’s Poopy Powder this year with the same results as Noflex.
I have had a Traxxas Villain for years that I've only run in salt water off the back of my boat. Just washed it off afterwards with fresh water...
Keith, Wow, great write up. Thank you I have been trying to decide how to handle my music for the boat so this gives me a great start. Did you...
Keith. Can you prove a little detail on how you ran the wires down into the salon? This is on my todo for the winter.
I have a suspicion the hose was never connected to anything from day 1. I don't see anything it should connect to in the bilge so I'm wondering...
Question for other 47 owners. Have you taken a close look at your shower sump? Look at the most aft connection, mine is labeled AC Condensate....
I don't believe the bottom shrunk but the top section of the windshield frame is pulled up causing the separation. [ATTACH]
There are no other issues with the boat. The boat has EZ2CY and no it does not seem to be pulling up on the frame in anyway. Hard to say how...
[ATTACH] [ATTACH] On the front rounded sections of my windshield, the plexiglass is separating from the frame. Has this happened to anyone and...
On our way to Block Island. Safe travels to all.
Thanks to all for your input! Mike
Yes, after cruise or a long run at no wake speed, starboard motor stays much colder than port motor. I didn't want to make any assumptions here...
Can anyone with QSC 600s tell me what your water temps are at slow speeds? I am seeing a big difference between my two motors at or slightly...
[ATTACH] The boat is fully loaded with fuel water and dinghy running at approx 21.5 knots. Port engine is at 84% load, starboard is at 82%.
I wish I was wrong but at 85% load, that is what vessel view shows.
