Port Bravo II drive won't go up

griff4

Member
Mar 19, 2013
115
Saint Pete Beach, FL
Boat Info
2007 Bayliner 325
Engines
2 350's w/Bravo II drives
Hi All! I suspect a bad "up solenoid" on my port side trim pump assembly. Ordered a solenoid yesterday. Has anyone else had to replace one of these? Thanks, Griff4.
 
Are you referring to the outdrive trim?
Did you try bypassing the trim limit sensor or using the trailer override?
 
Drive does not go up on the port side with either the trim button or the trailer button. So I think it's the up solenoid. The boat is now 9 years old and this is the first time for this problem. Thanks, Griff4
 
Drive does not go up on the port side with either the trim button or the trailer button. So I think it's the up solenoid. The boat is now 9 years old and this is the first time for this problem. Thanks, Griff4



Did you ever figure out your issue, I have the same issues but a little different both my drives (Bravo III’s ) don’t go up using switch on throttles but they will go up with trailer button I’m stumped....

2005 Sundancer 280 twin 5.0 MPI Bravo III’s
 
trim limit switch has gone bad if they wont raise with the trim button
 
You should have ordered two and did both up and down while you were in there cause when you remove one isn't much left to get there other one out.
 

Forum statistics

Threads
112,942
Messages
1,422,701
Members
60,927
Latest member
Jaguar65
Back
Top