Official 2003.5-2008 340 Sundancer Thread

Send it back to ray marine with 75 bucks and they will rewire the mic.
 
Hello all
I am wondering if anyone has had any issues with the dashboard push button modules? On My port side switch module the buttons have become difficult to push like the rubber has gotten hard and I can't turn things on and off this includes my bilge blower and my trim tabs. Does anyone know if there are replacement modules available and where I can buy them.

Last I checked, those pods come as one piece and are 3-400 bucks each and they come from the dealer.
 
I replaced mine with an Icom 424 and had techno graphic make a burl wood panel same as factory to cover up the hole.
 
crap, im burning alot more fuel on my port side, i was hoping some of it was due to the generator.
 
The small LED light at the top in my electrical panel in cabin does not work. Anyone have that happen and been able to fix? If so. How?


Sent from my iPhone using Tapatalk
 
Has any one used or have the RAY60. VHF AS a replacement
radio for the ray215 vhf . Did/does it fit in the same location
as the 215 ??
 
Last edited:
I had the same issue which was resolved when I cleaned the water connection points on the basket and on the microwave. There were a couple coffee grounds in each and when they were cleaned out, no more leaks. Hope it's that simple for you.
 
There are wires for the ACCY 1 and ACCY 2 located in the engine room near the breaker panel (short leads out of the panel). I use these switches for my Engine room camera and underwater lights.

What do these buttons on the starboard dash panel do?

 
Had same problem last year and it was driving me crazy. Ended up having my mechanic check the fuel pressure in each engine; supposed to be 40 and my port engine was at 70, which explained the higher fuel burn rate. Problem turned out to be the fuel pressure regulator in the cool fuel unit.
crap, im burning alot more fuel on my port side, i was hoping some of it was due to the generator.
 
The small LED light at the top in my electrical panel in cabin does not work. Anyone have that happen and been able to fix? If so. How?


Sent from my iPhone using Tapatalk

`
I thought I had the same issue, even replaced the light, until I figured out that the light is controlled by the floor illumination switch at the cabin door. Any chance this is your problem as well?
 
I have the same problem on my 380 Sundancer. I have checked it with every light switch and it does not turn on. It is an LED light, so I doubt it burnt out. Any other suggestions? I really want it to work.
 
It probably burnt out. I had a non working one in my 320. Purchased a replacement from the dealer, installed and worked perfectly. It was also activated by the light switch for the floor illumination lights. Took about two minutes to swap out.
 

Forum statistics

Threads
112,942
Messages
1,422,699
Members
60,927
Latest member
Jaguar65
Back
Top