Tomco
Active Member
- Aug 16, 2012
- 455
- Boat Info
- 2004 420 Sedan Bridge
GHS Hydraulic Lift
11' Walker Bay, 30hp
- Engines
- Cummins 6CTA 8.3M
I am adding a sea water anchor wash to our boat (2004 420DB) and would like to add a Carling breaker/switch in one of the blank accessory locations to power the pump. When I opened the DC panel it appears sealed with connectors mounted on the back for the wiring to enter/leave. Thought I'd check if anyone has added a switch and how they ran the wiring. If you look closely at the picture below, you can see the round connector in the middle (beside the ground bus bar) appears to have one empty pin with a white plug in it. The wiring from this plug goes to the AC switches on the right side of the panel ... guess you could use any empty pin. Hoping someone has experience they can share before going too far with this.
Thanks,
Tom
Thanks,
Tom