Slow progress

Socks

Member
Jan 7, 2019
45
Boat Info
1983 Sea Ray 270 Sundancer.
Engines
Twin 5.0L (305 ci) Mercruisers
This is my first time buffing a boat. I must admit, I like what i'm seeing. But, it is kicking my arse :) -- Thank goodness the oxidation isn't really bad. It's going to take a while to finish. As much as I want it done, I don't really have a time frame. I guess it will be finished when it's finished :).

I am really struggling trying to find something to remove the 'glue' from the strips. I have tried Goo Gone, Lacquer thinner, Paint remover, Acetone and rubbing alcohol. So far, my results are minimal. Any suggestions?

Thanks
buffing1.jpg
 
Are you sure it's glue and not raised gel-coat? Acetone should remove just about everything adhesive related.
 
That's not glue, looks like shading to me. Basically the gelcote under where the stripes were was not exposed to the elements and did not fade as much as the rest of the hull. If you are replacing the stripes it will get covered up, if not you will need to wetsand that area to blend the hull in with where the stiping was. You might be better to start with wetsanding the whole thing first. Then polish, wax etc.
 
I should have been more specific. The "strip line" in the picture isn't what i was referring to. Those strips came off clean. Some of the upper strips left a very sticky residue. Those are the ones I'm struggling with.

Thanks
 
Look for a product named “Sentinel 747 Adhesive Remover”.
 
Looks very nice so far! Overtones sells a product called stripe off. I have used it in the past with good results.
 
tiara in the snow 01.JPG
Go back to your acetone and be generous with a rag soaked in it. Make sure you keep the residue wet, and it will come off. Work in a ventilated area using personal protection gear.
 
Marine strip or goof off is my choice.
 

Forum statistics

Threads
112,944
Messages
1,422,723
Members
60,927
Latest member
Jaguar65
Back
Top