Separate names with a comma.
Voltage is always a suspect. Not just loose or corroded connections, but are the power cables of ample gauge for load? Are they terminated to a...
The KMC2 is a 2-wire power harness. You can wire the red to a constant, which it sounds like your #7 fuse is, and use the KMC2's power button to...
Find the amplifier for the tower speakers. It will have a power light illuminated if it has voltage and is turned on. Lights are normally green or...
No fuses for front or rear, just the entire amp. If the amp has all 4 RCA inputs populated, check the FADE in the head unit. Find the FRONT L&R...
Good question. As long as the back of the driver is not bumping against the inside, all is good. Depth is not as important, but total air space...
Ok, just using Fusion's advertised specs.
If you are not married to the Fusion, check into the Wet Sounds new Zero series. The Zero-8 has less mounting depth then even Fusion's 6.5".
I bet the speakers not playing and the woofer are on the same amp. By using designate subwoofer RCA, you are sending a filtered signal that lacks...
My first thought is that the media unit and the amp(s) need to share the same voltage source. So the media unit CANNOT be wired to the original...
If any of the hi-level speakers leads where used, then wht, gray, grn and prpl would be the same, if swapped color for color. My guess is that...
You DID NOT go with the wrong woofer, for the amp you had/have. Your only option was a 4 ohm woofer. My original 5 chnl suggestion was to upgrade...
In not sure exactly which Clarion amp model is there, but if my memory serves me right, its like 180W rms x 2 to a bridged 4 ohm load. The KMF104...
The MS-RA770 does not need a constant for memory. IIRC, it has non-volatile memory. While the yellow is the circuit that the 770 draws its...
And no credit to her mouth? What a dis!
Two things to avoid. Cutting a round hole in the vinyl thats the same as the speaker's ID. Compressing the foam and stretching the vinyl by...
